Publicité
Step 20
å
Carefully turn your unit onto its front edges. Unfold the BACK (BK1) and lay it over your unit.
å
IMPORTANT: Your unit must be "squared up" to the BACK (BK1) before fastening. Make equal margins along the top and
bottom edges of the BACK (BK1). Then, make equal margins along the side edges of the BACK (BK1). Push on opposite
corners of your unit if needed to make it "square".
å
BACK INSTALLATION:
1.
Begin fastening the BACK (BK1) using a NAIL (1N) through the hole shown at position 1.
2.
Be sure the edge spacing is even along the TOP (C), then use a NAIL through the hole shown at position 2.
3-4. Repeat this process for positions 3 and then 4 while keeping the edge spacing even.
5.
Continue fastening the BACK to your unit using the NAILS through all remaining holes.
NAIL
(38 used in this step)
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1N
5
4
1
These holes must
line up over the
center UPRIGHT (J).
STOP
The edge
spacing must
remain even on
all sides.
3
434912
8
C
2
BK1
Page 25
Publicité
