Publicité
WARNING: It is the responsibility of the users to ensure that they read, understand, and follow all instructions
and are trained in the care and use of this device. Training should be repeated periodically and any time there
is a change of components within the system. Training must be conducted without exposing the trainee to a
fall hazard
WARNING: Do not attempt to disassemble the unit or make repairs to the equipment. Send the equipment back
to the manufacturer, or persons or entities authorized in writing by the manufacturer to make repairs to the
equipment.
WARNING:
Cleaning after use is important for maintaining the safety and life of the equipment.
Use only mild soap and water, and hang to dry in shade.
MAINTENANCE, CLEANING & STORAGE:
•
Repairs to equipment can be made only by
a DEWALT representative or person or entity
DEWALT
authorized by
maintenance and repair.
•
Store the SRL in a cool, dry and clean place
out of direct sunlight. Avoid areas where heat,
moisture, light, oil, and chemicals or their vapors
or other degrading elements may be present.
Equipment which is damaged or in need of
maintenance should not be stored in the same
area as usable equipment. Heavily soiled, wet,
or otherwise contaminated equipment should
be properly maintained (e.g. dried and cleaned)
prior to storage.
•
Prior to using equipment which has been stored
for long periods of time, a Formal Inspection
should be performed by a Competent person.
Additional maintenance and servicing procedure
must be completed by authorized service center
only.
LIFESPAN:
•
The lifespan of any component of a personal fall
arrest system (PFAS) is dependent upon its level
of use, the environment in which it is used and
how it is maintained. Any part of the PFAS that
passes daily inspection by an Authorized person
or periodic (annual or semiannual) inspection
by a Competent person, can stay in use. Once it
fails visual inspection it must be removed from
service.
DEWALT
. Contact
for
NEVER use bleach or bleach solutions
TRAINING:
•
It is essential that the users of this type of
equipment receive proper training and
instruction, including detailed procedures for
the safe use of such equipment in their work
application. ANSI/ASSE Z359.2-2017, Minimum
Requirements for a Comprehensive Managed
Fall Protection Program, establishes guidelines
and requirements for an employer's managed
fall protection program, including policies,
duties and training, fall protection procedures,
eliminating and controlling fall hazards,
rescue procedures, incident investigations, and
evaluating program effectiveness.
DISCLAIMER:
•
Prior to use, the end user, must read and
understand the manufacturer's instructions
supplied with this product at the time of
shipment and seek training from their
employer's trained personnel on the proper
usage of the product. Manufacturer is not liable
or responsible for any loss, damage or injury
caused or incurred by any person on grounds of
improper usage or installation of this product.
PERIODIC EXAMINATION:
•
Always keep the instructions provided with the
product. Take the information from the markings
on the product and enter this information in the
identification sheet. To ensure the safety of the
user, it is essential to check the condition of the
equipment through periodic examinations of
the product. This equipment must be examined
by a competent person at least annually, strictly
complying with the manufacturer instructions.
Also, record the previous check on the attached
sheet. If the equipment is in heavy usage or is
used in a harsh environment, then the frequency
of inspection should be increased in accordance
with regulations. Also check that the markings
on the product are legible.
English
to clean SRL.
23
Publicité
