Publicité
WARNING: ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
For using the DEWALT personal SRL's as a twin-leg option, assemble two DEWALT personal SRL'S to connect
under the webbing below the dorsal D-ring of the harness with the help of a special connector* (e.g.
DXFP990151). When using the DEWALT personal SRL'S as a twin-leg lifeline, then ensure 100% tie off at
all times. Make sure to disengage one hook from the anchorage structure only if the other hook is firmly
connected to the anchorage structure.
TWIN SRL Connector* Technical Specification
Model
Material of
Construction
DXFP990151
Alloy Steel
SRL CONNECTOR SOLD SEPARATELY*
Open connector
by pushing the
locking lever
and push button
at the end
simultaneously.
Fig.6
Slide Connector
through Pre-
Installed channel
below the Dorsal
D-ring.
Fig.7
Push the pin
inside the
grooves of the
connector to
ensure locking.
Fig.8
Minimum
Breaking Strength
5000 lbs. (23kN)
Fig.6
Fig.7
Fig.8
Now the block is
ready to use.
Fig.9
TIE BACK SRL's
INSTALLATION OF DEWALT SRL WITH TIE-BACK HOOK
DEWALT SRL with tie-back hook should be used with
the SRL casing attached to the Dorsal D-ring of the
full body harness, and the extended webbing (with
a sheath) wrapped around the anchorage structure,
and the tie-back hook secured around the webbing.
•
For tie-back applications, only use the models
identified for tie-back applications.
•
Connection location must independently support
5000 lbs. (23kN)
25) ADDITIONAL INFORMATION FOR SELF-
RETRACTING LIFELINES
Always tag as "Unsuitable" those SRL's which have
been found to be unsuitable for further use. Never
attempt to repair the equipment on your own. Send
the equipment so tagged to an authorized service
center (where the authorization has been received
from the manufacturer in writing), or back to the
manufacturer for replacement of components and
repair.
English
Fig.9
STRUCTURAL ANCHOR(I-BEAM)
SNAP HOOK
ENERGY ABSORBING PACK
TO THIS EYE HOLE, ATTACH CARABINER
TO APPLICABLE HARNESS
13
Publicité
