Publicité
• The device may never be operated without super-
vision.
• Never subject the device to water or other liquids.
• The device may neither be operated in rooms with
a bathtub, shower or swimming pool nor near
washbasins or water connections.
• The distance between the device and flammable
objects must be at least 75 cm.
• The device may not be covered. There is danger
of fire.
• Do not use the heater in conjunction with a timer
or any other switch capable of automatic activa-
tion, as this creates a fire hazard.
• The heater must not be positioned beneath a wall
socket.
• Do not use adapters or extension cords.
• Never pull on the mains cable to move the device.
• This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• Children of less than 3 years should be kept away
unless continuously supervised.
• Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
• CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
To prevent overheating, do not cover the
heater!
DANGER! Risk of death through electric
shock! The use of this variant outside Swit-
zerland is not permissible for safety reasons,
as this poses a risk of electric shock or fire.
The variant of the product sold in Switzerland may
only be used in Switzerland, as it is equipped with a
Swiss plug.
You can identify the variant by means of the item
number on the product (the instructions always con-
tain all item numbers):
• Item number Switzerland: 476982
• Item number in other EU countries: 477969,
235684
Your device at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, fig. 1
1. Heat level switch (I, II)
2. Temperature regulator
3. Mains cable bracket
Scope of delivery
• Radiator
• Rollers (4×)
• Brackets (2×)
• Cross braces (2×)
• Wing nuts for cross braces (2×)
Assembly
► P. 3, fig. 2
– Place the device upside down on a flat, stable sur-
face, ensuring it will not tip over.
► P. 3, fig. 3
► P. 3, fig. 4
– Hook in the brackets on the underside of the
device on the left and right between the last and
next-to-last rib.
► P. 4, fig. 5
► P. 4, fig. 6
– Guide the ends of the bracket through the hole in
the cross brace and tighten with wing nuts.
– Set the device upright and wait at least three min-
utes for the oil to settle before turning on.
Operation
Check before switching on!
DANGER! Risk of injury! The device must
only be put into operation if no faults are
found during the check-up. If any part of the
device is defective, it must be replaced
before the next use.
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the device are firmly
attached.
– Check whether the switch is on [0] before you
insert the plug into the outlet.
Electrical connection
– Connect mains cable to outlet.
DANGER! Risk of injury! The device may
not be mounted directly below a wall outlet.
Danger of cable fires!
Heat levels
► P. 4, fig. 7
With the heat level switches (I, II), the device can be
operated at three different output levels:
• Only switch A = low heating power;
• Only switch B = medium heating power;
• Switches A and B = high heating power.
The set heating power is indicated by the control
lamps (8).
GB
21
Publicité
