Publicité
AIRFUSION NAUTICA - REMOTE CONTROL
REPAIRING THE REMOTE & RECEIVER PAIRING – WHEN 1 CEILING FAN IS INSTALLED
•
If the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired.
•
Below are the operating symptoms and the steps to repair the pairing of the remote and receiver.
Symptoms:
•
Loss of control - Fan is only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with the receiver
59 | Page
Speed control
(1)
There are 6 available speeds. "I" button is for the lowest speed,
and "VI" button is for the fastest speed.
NOTE: when you turn on the fan for the first time or switch the
main power to the controller, you need to start the fan on high
"VI" speed first and then choose a lower speed. A 5-10 seconds
is required to allow the DC fan to respond to the remote each
speed or fan direction selections.
Fan On/Off
(2)
Reverse control
(3)
Light On/Off
(4)
Publicité
