Publicité
Commissioning
Twist to
1
release the
emergency
stop button.
Waiting for about 1 minute, check the voltage of the series circuit
3
displayed on the inverter.
The voltage should be module open circuit voltage* the number
of modules.
Note:
• The power supply of the XRSD-Core Kit MUST be on the same AC branch circuit
as the inverter in order to meet the rapid shutdown requirement.
• After installing XRSD and XRSD-Core Kit, place the rapid shutdown system label
within 1m of the emergency stop button or AC disconnect.
• After installation is complete, fill gaps around pipes both outside and inside with
seal putty.
70
Turn the DC
2
switch of the
inverter to
ON positon.
seal putty
Publicité
