Publicité
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL WARNINGS, CAUTIONS
AND OPERATING INSTRUCTIONS BEFORE USING THIS
EQUIPMENT. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal
injury.
WARNING:
not use with an extension cord near water or where water
may accumulate. Keep work light at least 16 feet from
pools and spas. Keep plugs and receptacles dry. Use only
three-wire outdoor extension cords with grounded plugs
and grounded receptacles.
Ground Fault Circuit Interrupter (GFCI) protection
•
should be provided on the circuit(s) or outlet(s)
be used for this light in wet locations. Receptacles are
available having the built-in GFCI protection and are able
to be used for this measure of safety.
Use only with an extension cord for outdoor use,
•
such as an extension cord of cord type: SW, SW-A, SOW,
SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A,
SJOW, SJOW-A, SJTW, SJTW-A, or SJTOW, SJTOW-A.
Do not look directly at the lighted lamps to avoid eye
•
injuries.
Always keep the work light away from any flammable
•
surface or materials.
Always check damaged or worn-out parts before
•
using the work light. Broken parts will affect the work
light operation. Replace or repair damaged or worn parts
immediately. If repairs are needed, consult a professional
electrician.
Do not use a pressure washer to clean this product.
•
Do not modify the work light in any way. Unauthorized
•
modification may impair the function and/or safety and
could affect the life of the product. There are specific
applications for which the work light was designed.
Store work light in a secure place out of the reach of
•
children. Inspect it for good working condition prior to
storage and before re-use.
WARNING:
a Lithium-ion battery. Lithium-ion batteries are small,
compact, and ideal for providing long-lasting power to
this product. However, they must be used and charged
properly. Improper use can result in serious injury, fire,
or death.
CAUTION:
This product comes with a battery
installed internally. Do not attempt to remove the battery
from the product.
Do not place this lithium-ion battery-powered product in
•
fire or apply heat to it.
Do not apply strong impact or shocks to this lithium-ion
•
battery-powered product.
Do not allow the lithium-ion battery to get wet.
•
Do not leave this lithium-ion battery-powered product in
•
the direct sunlight, or use or store it inside cars in hot
weather. Doing so may cause the battery to generate
heat, rupture, or ignite. Using the battery in this manner
may also result in a loss of performance and a shortened
battery life.
NEVER THROW WATER ON A BURNING LITHIUM-ION
•
BATTERY! If a lithium-ion battery does catch on fire, it
RISK OF ELECTRIC SHOCK, Do
This LED light is powered by
English
IMPORTANT SAFETY INSTRUCTIONS
will burn even more violently when contacted with water.
Store the product at temperatures between 41°F and
•
77°F (5°C and 25°C).
Properly dispose of all batteries at a recycling center
•
or per local code. More information regarding battery
disposal in U.S. and Canada is available at; http://www.
rbrc.org/index.html, or by calling 1-800-822-8837
(1-800-8BATTER).
caLiFoRnia pRoposition 65 WaRning
This product can expose you to Lead and other chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Wash your hands after
handling. For more information go to www.P65Warnings.
ca.gov.
to
ASSEMBLY INSTRUCTIONS
attacHing WoRk LigHt HeaD to stanD
1.
Place the H-stand (8) on a flat surface.
2.
Position the U-Shaped bracket (6) of the work light head
against the stand (8) as shown in FIG 1.
3.
Use the locking knob (7), flat washer and spring washer
to secure the work light head on the H-stand.
This hybrid light can operate in either AC-powered mode or
battery-powered mode.
ac-poWeReD LigHt MoDe
To operate the light in AC-powered mode, connect the built-
in AC input port (10) on the back of the light to a 120V
AC power source using the included extension cord or any
standard extension cord.
When the light operates in ac-powered mode, only the
ac LeDs (2a-Fig 2) are illuminated, providing up to 5000
lumens of brightness, as shown in Fig 2-a.
When connected to 120V AC power, the light operates
exclusively on AC power. The battery-powered DC LEDs
(2b-FIG 2) remain inactive during this time.
BatteRY-poWeReD LigHt MoDe
The light operates in battery-powered mode only when the
light is not connecting to AC power.
When in battery-powered mode, only the Dc LeDs (2b-Fig
2) illuminate, providing up to 1000 lumens of brightness,
as shown in Fig 2-B.
cHaRging tHe BatteRY
The built-in lithium-ion battery can be charged through the
AC input port (10) when the light is connected to AC power .
sWitcH Button
When the light is connected to AC power, press the switch
(4) once to turn on the AC light, and press it a second time
to turn it off.
When the light is NOT connected to AC power, press the
switch (4) once to turn on the DC light at 1000 lumens,
3
OPERATION
Publicité
