Publicité
SWIMMING POOL HEAT PUMP TYPE PX
4. OPERATION AND USE
4.1Color screen wire controller interface
introduction
4.1.1 Main interface
4.1.2 Button Description
NO.
Name
ON/OFF
Function
Setting
CLOCK
Fault display
Silent setting
MODE
Temp. curve
Water
nlet Temp.
LOCK
WWW.NORSUP.EU
16
The button function
Press to start /shut off the unit
Click this button to enter function
selection interface,
Press to set the clock, the timer on or timer off.
When the timer was starting, the button is
green
Click to view fault history
Click to turn on/off silent function and to
set timing Low speed function.
Click to enter mode setting and the target
temp. Setting interface
Click to view the temp. and power curve
Click to enter mode setting and the target
temp. Setting interface
Click to lock the screen, input "22" to
unlock the screen by press the "lock"
button
Alterations which serve the technological progress as well as errors excepted!
SWIMMING POOL HEAT PUMP TYPE PX
4.2. Color screen wire controller function introduction
4.2.1Booting and shutdown
As shown in figure 1.1:
In shutdown status, click
then the unit will be booted;
In booting status, click
then the unit will be shut down.
4.2.2 Mode switch and target temperature Setting
(1) Mode switch
In the main interface, click the mode button or inlet water temperature
setting button, interface displays as follows:
Click the cooling mode button
mode button
then you can select the corresponding mode.
Note: When the unit is designed for single cooling mode or single
heating mode, the mode can not be changed.
(2) Target temp. setting
Click the temperature set button
Alterations which serve the technological progress as well as errors excepted!
, automatic mode button
or heating
, you can set the target temperature.
ORIGINAL MANUAL NORSUP
EN
DE
EN
NL
DE
FR
DA
SV
17
Publicité
