Publicité
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.
Blade replacement indicator light is on.
Two inner lights flashing on battery indica-
tor. Mower will not start.
Two outer lights flashing on battery indica-
tor. Mower will not start.
This product has a Five-year Limited Warranty for personal,
family, or household use (One-year for business or commercial use).
For warranty details, visit www.ryobitools.com
TROUBLESHOOTING
POSSIBLE CAUSE
Handle adjustment pins are not in place.
Battery is low in charge.
Start key not installed.
Debris in battery compartment.
Handle assembly is not in operating posi-
tion.
Lawn is rough or cutting height not set
properly.
Blade is unbalanced, excessively or un-
evenly worn.
Wet grass clippings sticking to the under-
side of the deck.
Blade is unbalanced, excessively or un-
evenly worn.
High grass, rear of mower housing and
blade dragging in heavy grass, or cutting
height too low.
Cutting height set too low.
Grass blocking rear chute of mower.
Blade is unbalanced, excessively or un-
evenly worn.
Bent motor shaft.
Cutting height set too low.
Check if blade needs replacing.
Overcurrent, excessive load on mower blade. Raise cut height and ensure deck is clear of
Batteries over the temperature limit.
or call (toll free) 1-800-525-2579.
14 — English
SOLUTION
Pull up handle adjustment lever, release,
and make sure handle adjustment pins lock
into place.
Charge the battery.
Install start key.
Ensure nodes and
terminals are clear of debris.
Raise lower and upper handle.
Adjust the cutting height.
Replace the blade.
Wait until the grass dries before mowing.
Replace the blade.
Raise cutting height.
Raise cutting height.
Stop the motor, remove start key, and bat-
tery. Remove grass catcher bag and remove
the blockage.
Replace the blade.
Stop the motor, remove start key, and battery.
Inspect for damage. Have repaired by an
authorized service center before restarting.
Raise the cutting height.
Replace blade if necessary and reset blade
replacement indicator.
debris. If mulching, recommend change to
bagging or side discharge to lighten the load.
Bring batteries inside to cool off. Put mower
in the shade or cool area until batteries stop
displaying the error message.
Publicité
