Publicité
• not to let children, or those unable, use the cabinet keys or controls (including remote controls) even if only to play with;
• not to operate the barrier until it is completely in view;
• not to enter within the operating range while it is moving, wait for it to stop;
• not to rest against the bar or cabinet for any reason, even when the barrier is inactive and do not remain within the opera-
ting range of the barrier;
• not to let children or animal play within the operating range of the barrier;
• not to use the barrier for purposes (e.g. lifting of weights or persons) other than those foreseen. The manufacture holds no
responsibility what so ever for damages caused by the said actions;
• to perform periodic maintenance by specialised personnel;
•
if there is a fault, turn off the power supply. Use the manual manoeuvre only if safe. Do not attempt to resolve the problem
yourself, contact a qualified technician of the manufacturer or authorised by the manufacturer. In any case, make sure that
the spare parts are original so that the safety of the barrier is not compromised..
8.
MAINTENANCE AND DURABILITY OF THE PRODUCT
6
1
4
1
• Restore the mains power and check:
- The intervention of safety devices and light signals.
- Obstacle detection.
- Possible risk of lifting.
- Dangerous situations and force limitations according to EN 12445
Interventions of ordinary maintenance every 300.000 cycles or every 36 months:
Remove the mains power and any buffer batteries, then carry out the following checks and replace the worn parts if necessary.
- Carry out all the points indicated above on "Interventions of ordinary maintenance every 150.000 cycles or every 6 months".
- Replace the balancing spring (2).
9. TROUBLESHOOTING
This paragraph deals with the most probable causes of common faults, in order to promptly re-establish the barrier.
In any case the indicated case study is incomplete (both from a cause point of view as well as a fault point of view).
a_ The barrier is blocked (open, closed or half-open):
1_ no power supply;
2_ inefficient commands;
3_ blown power supply fuse;
4_ photocells (also enabled during opening) active because they are incorrectly aligned and/or covered (grass, etc);
b_ the barrier continues to open and close;
4
3
2
Product durability:
The durability of the product is influenced by the severity of use.
In any case, the durability estimate for use in medium-hard con-
ditions is 3.000.000 cycles.
The durability estimate does not represent any explicit guaran-
tee on the actual duration of the product.
Ordinary maintenance frequency:
Interventions of ordinary maintenance every 150.000 cycles or
every 6 months:
• Remove the mains power and any buffer batteries, then carry
5
out the following checks and replace the worn parts if necessary:
- Check the balance of the boom (see chapters "Bar fixing,
Spring fitting and Bar balancing ";
- Check the electrical connections and if the ground con-
nections are still intact;
- Check the correct functioning of the circuit breaker and the
differential switch.
- Check the tightening of the bolts. (1)
- Check the correct fixing of the spring (2) and tie rods and if
they are still intact (3).
- Check the wear of the mechanical stops and the adjustment
of the limit switches (see chapters "Electric limit switches -
adjustment (LUXE-SE) and Mechanical stops adjustment"). (6)
- Clean and grease the joint (4)
- Check the manual release (5)
- Clean the photocell eye using a damp cloth. Do not use sol-
vents or other corrosive products.
- Eliminate any plants or weeds within the barrier's range of
action and check if the warning sign is intact.
24
Publicité
