Publicité
6.5 Modification of the barrier with opening to the left (SX)
After releasing the automation (see the "Manual release" chapter), proceed as follows:
1_ Remove the connecting rod by taking away the fixing screws and lower the rocker arm until it stops. Crank the handle as
shown in the picture, rotate the lever 180° to the previous position and tighten it to the opposite side of the rocker arm.
2_ Once the opening direction has been modified, invert the motor connections (see K206MA instructions). If the barrier must
be modified from LH to RH, the operations are the same.
Step 1
6.6 Bar fixing
All operations must be carried out with the power OFF.
After releasing the automation (see the "Manual release" chapter), proceed as follows:
1_ using a support, bring the bar in the horizontal position (wholly assembled and with all the accessories) near the bar sup-
port and fix with the omega bracket and the screws supplied;
Note: the bar must be inserted for the whole length of the omega bracket.
D
Step 2
A
B
A
C
Step 3
Step 4
2_ LUXE-M + AE: when the omega bracket is fixed, and after
removing the protective cap, pass the LED cable through
the hole on the cabinet (to take the cable to the control
unit, refer to figure) then fit the cover and secure it with
the screws supplied;
A) Position the led connection cable "A".
B) LED stripes
C) 90° articulated cable gland
D) Tear proof cable seal
20
Step 5
Publicité
