Publicité
GOURMETmaxx Glass Kettle
CLEANING
Please Note!
■ The device is not dishwasher-safe.
■ Do not use any sharp or abrasive clean-
ing agents or cleaning pads to clean the
device. These may damage the surfaces.
Wipe off any dirt with a damp cloth.
Remove possible limescale deposits to make
sure that the kettle works properly. To do
this, use a standard descaling agent for
kettles as follows:
1. Pour a mixture of water and descaling
agent into the kettle (8) and switch it on.
Consult the instructions for using the
descaling agent with regard to the ratio
of water to descaling agent.
2. After it has boiled, empty the kettle.
Do not drink this water!
3. Refill the kettle with water at least once
more and bring it to the boil to remove
any possible residues from the descaling
agent. Pour away this water and do not
drink it!
STORAGE
• Disconnect the base station (6) from
the mains power when the device is not
going to be used for a prolonged period.
Clean the device again if necessary (see
the "Cleaning" chapter) and let it dry
completely.
• You should store it in a cool and dry place
which is out of the reach of children and
animals.
TROUBLESHOOTING
If the device does not work properly, check
whether you are able to rectify the problem
yourself. If the problem cannot be solved
with the steps below, contact the customer
service department.
Do not attempt to repair an
electrical device yourself!
The device does not work.
The device has overheated.
► Wait until it has cooled down, pour
in water and try again.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit of the mains plug.
The plug socket is defective.
► Try another plug socket.
The fuse in the fuse box is triggered.
Too many devices are connected to the
same circuit.
► Reduce the number of devices in the
circuit.
Water runs out of the device.
There is too much water in the kettle (8).
► Do not fill the kettle above the MAX
mark (9)!
The device does not switch off.
The On / Off switch (3) is blocked.
► Remove the blockage.
The device switches off during the
boiling process.
The amount of water has dropped below
the MIN mark (7).
► Pour water at least as high as the MIN
mark into the kettle (8).
A large amount of steam is produced
during boiling.
The device is furred up.
► Descale the device.
EN
13
Publicité
