Publicité
EN
BEFORE INITIAL USE
1. To remove any possible production
residues, fill the kettle up to the MAX
mark with water before you first use it
and switch it on. To do this, follow the
instructions in the following chapters.
2. Pour away the water after boiling. Do
not drink this water!
3. Perform this process twice.
SET-UP AND CONNECTION
Please Note!
■ Only connect the base station to a
properly installed plug socket. The mains
voltage must match the technical data
of the device.
■ Do not place the device below kitchen
wall units or similar cupboards. The rising
steam could cause damage to them!
■ Lay the connecting cable in such a way
that it does not become crushed or
kinked and does not come into contact
with hot surfaces.
1. Unwind the connecting cable on the
bottom of the base station (6) to the
length you want and then place it in the
recess which is provided for it on the
edge.
2. Always set up the device with a clear
space at the sides (at least 20 cm) and
clear space above it (at least 30 cm) on
the kitchen worktop or another flat,
solid and heat-resistant surface that is
resistant to splashing.
3. Plug the mains plug into a plug socket.
The plug socket must be readily accessi-
ble so that the connection to the mains
can quickly be isolated.
12
USE
Please Note!
■ Each time before you boil water, make
sure that the On / Off switch is not
blocked. The kettle will only switch off
automatically after the boiling process
finishes if the On / Off switch is not
blocked.
■ The lid must always be closed during
operation.
■ Never operate the device without water
or with the water level below the MIN
mark. It could overheat. In this case,
the device switches off. Allow it to cool
down before refilling and reusing it!
1. Pull the release button (2) for the lid
towards the handle (4) and open up the
lid (1).
2. Fill the kettle (8) with at least 0.5 litres
(MIN mark, 7) and no more than
1.7 litres (MAX mark, 9) of water.
Insufficient water will cause the device
to switch off prematurely. If the MAX
mark is exceeded, water could splash
out during the boiling process.
3. Flip the lid shut. It must engage.
4. Place the kettle on the base station.
5. Move the On / Off switch (3) to position I.
The device and the LED lighting (5) are
switched on.
L
The boiling process can be aborted
at any time by moving the On / Off
switch to position Ο.
6. The device switches off automatically
as soon as the water boils. The On / Off
switch flips to position Ο and the LED
lighting goes out.
7. Take the kettle off the base station and
carefully pour the water into a vessel.
Publicité
