Publicité
Mounting on hollow wall
•
Use the bracket (5) as a template to mark the driling position with marker. It is
recommended that the lower holes are 80cm above the floor. (see Fig. 4a)
•
Drill holes with drill bit (Ø 10mm).
•
Insert plastic anchors into the holes, then securely fasten the wall mount bracket with
screws and washers on the wall. (see Fig. 4b)
•
Hang the hose reel on the wall mount bracket, then secure with inserting the mounting
tube.
•
Connect the inlet hose (6) to the water supply.
Hose stop adjustment
•
Pull the lever to open the stop ball (1). (see Fig. 5a)
•
Freely adjust the loctaion of the stop ball along the hose. (see Fig. 5b)
•
Fix the stop ball by locking the lever in position.
Fig. 4a
Fig. 5a
Fig. 4b
Fig. 5b
Page 12 / 22
Publicité
