Installation - Weinmann & Schanz E200 Manuel D'utilisation Et D'installation

2. Installation

Installation location
The device should be installed in a location in the room which:
• is easily accessible for operation
• is free of curtains, cabinets, shelves, etc.
• allows for free air circulation
• is not subject to direct sunlight
• is not subject to draught (e.g. when windows/doors are opened)
• is not subject to direct influence from the heating sources
• is not on an outside wall
• is about 1.5 m above the floor
The controller must be installed directly onto the wall or on a flush-mounting socket.
1. Loosen the screws below the battery cover.
2. Remove the front cover by pressing the button on the bottom of the housing. (see Fig. 1)
3. Attach the back plate to a flush-mounting socket using suitable wall plugs and screws.
4. Complete the wiring to the heating source according to the wiring diagram inside the product
or below. (see Fig. 2)
5. Mount the front cover by pushing it fully onto the back plate.
6. Tighten the screws
7. Install the 2 AA batteries provided.
47