How To Change User Options - Weinmann & Schanz E200 Manuel D'utilisation Et D'installation

9. How to change user options

The controller offers a number of options that can be changed by the user (see Table 1.).
To activate the menu,
Select an option
Change an option
Press < or > to accept each change.
To exit the menu, press the < and > buttons simultaneously for 3 seconds.
If no button is pressed within 2 minutes, the device will return to the auto mode.
9.1 How to change from 24h to 12h clock (option 1, table 1 table 1 on page 45)
Shows the time as 24 hours or 12 hours
9.2 How to change the manual set point temperature (option 2, table 1 on page 45)
Setting the temperature used when the manual mode is selected for the first time, e.g. 20 °C
9.3 How to change to another pre-set program (option 3, table 1 on page 45)
Selection of a pre-set program to be used for programming events (see 7.).
42
in AUTO Mode press the < and > buttons simultaneously for 3 sec-
USEr00
onds, will be displayed
by pressing the < or > button
by pressing the + / – button