Publicité
Insert the included steel tube
into the ground sleeve
before the
3
4
concrete hardens. Then use a spirit level to check the vertical position
of the product (see Fig. D).
After the concrete mass has completely hardened, you can now insert
the column
into the steel tube
in the ground sleeve
. To do
7
3
4
so, remove the protective cover
from the column
.
6
7
You can now use the product.
Use
Opening the product
To open the product, push the star component
upwards until it
9
encounters resistance and locks into place.
Note: Make sure that the washing lines
do not get tangled –
1
otherwise this prevents the product from spreading out.
Re-tightening the lines
To re-tighten the washing line
, undo the knotted strings at the ends
1
of the arms
.
2
Pull the washing line
from bottom to top until they sit taut.
1
Then firmly knot the washing line
again.
1
Closing the product
Remove all objects from the washing line
.
1
Release the grip button
on the column.
8
Pull the star component
downwards as far as it will go.
9
20 GB/IE
Publicité
