Publicité
Do not sit or lean on the product.
Do not exceed the product's maximum load capacity of
50 kg
50 kg.
If you would like to secure the ground sleeve into a lawn, make sure
that the cap is just below ground level in order to prevent damages
when mowing the lawn.
Installation
Choose a suitable location in which the product can freely rotate when
spread out.
Encasing the ground sleeve in concrete
If you would like to set up the product in a location with a sandy or
rocky surface, encase the ground sleeve
firmly positioned.
If you would like to secure the ground sleeve
sure that the cap
damages when mowing the lawn (see Fig. A).
Dig a hole with a width of 26 cm and a depth of approx. 36 cm (see
Fig. B).
Mix a fairly dry concrete mass with 3 parts gravel, 2 parts sand and
1 part cement.
Partially fill the hole with this concrete and position the ground sleeve
. The ground sleeve
4
Fig. C).
Hold the cap
sleeve
.
4
is just below ground level in order to prevent
5
must be just below the ground level (see
4
in position so that no concrete gets into the ground
5
in concrete to ensure it is
4
into a lawn, make
4
GB/IE
19
Publicité
