Publicité
SilverCrest SSSES 1.5 B1
7.3 Filling up the soap
Pour the pre-prepared soap mixture into the soap dispenser.
•
Open up the lid (5).
•
Remove the plug (4) from the soap tank (3). Twist the plug (4) slightly from side to side
to make it easier to remove.
•
Pour the soap mixture into the soap tank (3); fill to at least the 'min' line and no further
than the 'max' line of the fill level indicator (8).
•
Insert the plug (4) back into the opening of the soap tank (3).
•
Close the lid (5).
8. Initial use and operation
8.1 Switching the device on and off
Switch on the soap dispenser by briefly pressing the ON button (1) under the lid (5). The
LED (9) will turn yellow briefly.
Press the OFF button (2) under the lid (5) to switch off the soap dispenser. The LED (9) will
turn red briefly.
Only switch off the soap dispenser if it not being used for prolonged periods,
for example during holidays.
8.2 Dispensing the lather
Hold your hand beneath the sensor (6) and dispensing nozzle (7). The lather will now be
dispensed and the LED (9) will flash yellow. The device will automatically stop dispensing
after a few seconds or when you remove your hand from under the sensor (6).
Any excess lather on the dispensing nozzle (7) can simply be wiped off with
your finger after the lather has been dispensed.
If you want the device to stop dispensing sooner, simply move your hand
down. This way, all the lather will land on your hand.
9. Storing the device when not in use
If the soap dispenser is not going to be used for a long period of time, remove the batteries.
Keep the soap dispenser in a cool, dry place.
28 - English
Publicité
