Leatt SNX 5.5 Manuel D'utilisation page 3

SNX 5.5

Brace Setup

Please follow the steps to fit your neck brace

Before you put on your 5.5 neck brace pull the rear thoracic back till it is stopped.

Open the brace by pushing the release button underneath the right side of the brace (2a). You can now

pull the brace open (2b).

Back

Front

Fit the brace with the rear thoracic facing your back (3a). Close the brace, there should be a click to confirm

that it is closed (3b).

Corporation

Correct fitment

Please ensure that the brace wing tips are correctly aligned over your shoulder as shown below:

The size of the brace should be correct for your body shape and allow for adjustability to ensure correct fitment

and comfort. When correctly adjusted and worn with your helmet, the 5.5 neck brace should allow for a full safe

range of a rider's head and neck movements (i.e. looking up, looking down and looking side-to-side, such as

when performing an over-the-shoulder check); the 5.5 neck brace and the helmet must come into contact

with each other as the full safe range of normal riding head movement is reached. (5a)

Check that you have the right helmet rim clearance. Please use assistance to do this measurement, do not do

it yourself. Place a ruler in the middle of the upper rim of the brace at 90

a neutral (level) position (5b). Remember to do front and back. The helmet rim should be within the zone of

optimum effectiveness (5c)

If any resistance or discomfort is experienced when attempting to complete the full safe range of head and

neck movements, or if the brace does not make contact with the helmet when the full range of movement

is reached, further adjustment, or an alternative size of 5.5 neck brace may be required. In extreme

circumstances, it may be necessary to purchase an alternative model of helmet in order to achieve the

required level of compatibility and safety.

If the brace interferes with any of the above mentioned, please move on to the adjustment section (p6). Please

ask the retailer or contact Leatt ® if you require further advice on sizing, adjustment or fitting.

Corporation

170mm

130mm

50mm

to the ground, with your head in