Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English | 19
Adjusting the Brightness
Press the On/Off switch 9 briefly to switch on the cordless worklight at maximum
brightness. To adjust the brightness in 2 stages, hold down the On/Off switch 9 until
the required brightness is obtained.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 50 °C, the cordless worklight
switches off. Allow the cordless worklight to cool down, then switch the cordless
worklight on again.
Working Advice
The cordless worklight runs at reduced brightness when the battery capacity is at ap-
prox. 1.3 %. The cordless worklight flashes 3 times before the brightness decreases.
Swivelling the Lamp Head (see figure A)
The lamp head 1 can be swivelled up to 200° to suit the application.
– As an uplight with the lamp head aimed upwards.
– Swivelled 90° to shine light into the room.
– With lamp head tilted approx. 120° for glare-free lighting of the work area, e. g. a
desk.
– With lamp head tilted approx. 200° to illuminate the floor.
Note: At a tilt of more than 90° the cordless worklight has to be fixed.
Utility Hook (see figure B)
You can use the utility hook 7 to attach the cordless worklight to an object.
Carabiner (see figure C)
You can use the carabiner 4 to attach the cordless worklight e. g. to a rope or belt.
Magnetic Mount (see figure D)
You can use the magnetic mount 6 to attach the cordless worklight to ferromagnetic
surfaces. Do so carefully in order to avoid scratching delicate surfaces.
Tripod Mount (1/4") (see figure E)
You can use the tripod mount 8 to screw the cordless worklight onto a tripod.
Maintenance and Service
Maintenance and Cleaning
When the battery is no longer operative, please refer to an authorised after-sales ser-
vice agent for Bosch power tools.
The cordless worklight is maintenance-free and contains no components that must be
replaced or maintained.
Bosch Power Tools
1 609 92A 0GE | (6.3.14)
Publicité
Table des Matières
