Publicité
Except KD-55X720F
1
Detaching the Table-Top Stand from
the TV.
To detach the Table-Top Stand from the
TV, remove the screws.
Note
Note
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
• When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
• When removing the Table-Top Stand from
the TV, lay the display face down in a stable
work surface that is larger than the TV.
• To prevent damaging the surface of the LCD
display, make sure to place a soft cloth on
the work surface.
2
Attach the Wall-Mount Bracket (not
supplied) using the screws (not
supplied).
Screw (not supplied)
Wall-Mount Bracket
(not supplied)
Soft cloth
Note
Note
• If using an electric screwdriver, set the
torque at approximately 1.5 N·m {15 kgf·cm}.
42
US
Installing the TV against a
wall or enclosed area
Ventilation
• Never cover the ventilation holes or
insert anything in the cabinet.
• Leave space around the TV set as
shown below.
Installed with Stand
11
4 inches
(10 cm)
Leave at least this much space around the set.
Installed on the wall
11
(30 cm)
4 inches
(10 cm)
4 inches
(10 cm)
Never install the TV set as follows:
Air circulation is
blocked.
Wall
Note
Note
• Inadequate ventilation can lead to overheating
of the TV and may cause TV damage or cause a
fire.
7
/
inches
8
(30 cm)
4 inches
(10 cm)
7
/
inches
8
4 inches
(10 cm)
Leave at least
this much space
around the set.
Air circulation is
blocked.
Wall
3
2
/
8
inches
(6 cm)
Publicité
