Rawlplug R-WW90II Mode D'emploi page 9

WW90 II
tool design, sparks may appear during its operation.
Exhaust fumes released by the tool also pose a
potential risk of ignition of flammable fuels or
gases. Do not use the tool in any places where this
may be the case. Smoking is prohibited while using
or carrying the tool and its gas container.
Before switching the tool on, check:
1.
- if the tool is fully operational,
- that no moving parts have changed their original
position or jammed, and eliminate any other
conditions which may affect the tool operation.
2. The gas container is a high-pressure liquid gas
cylinder. Keep it away from sparks, fire or heat
and potentially explosive atmospheres.
3. Do not pierce the cylinder or attempt to open the
gas cartridge. Do not incinerate the cylinder when
it is used up. Follow the recycling instructions
provided on the cylinder.
4. The gas container is not refillable.
Do not store the tool, its batteries or gas
5.
containers at temperatures above 50°C (120°F).
High temperature may lead to an explosion or fire
and release of combustible gas. When not in use,
keep the tool away from heat and direct sunlight.
The tool should be used in properly ventilated
6.
rooms. Do not inhale exhaust fumes, vapours or
gas, as they pose a potential threat to the human
body.
7. Keep your body well balanced and stable, and
avoid leaning too far when using the tool.
8. Keep the tool, its gas container, charger and
battery pack away from children. Using the tool
by an untrained person poses a hazard. Persons
under the influence of alcohol, narcotics or drugs
affecting their psychophysical condition are
forbidden to operate the tool.
SAFETY INSTRUCTIONS FOR NAILERS –
PRECAUTIONS FOR SAFE NAILER HANDLING
- Always assume that the tool contains nails, and
that it is ready for operation. Careless handling of
the nailer may result in incidental ejection of nails
leading to personal injury.
- Do not aim the tool at yourself or anyone else.
Unexpectedly pulling the trigger will cause nail
ejection, and may cause injury.
- Before pulling the trigger, make sure that the tool's
16
www.rawlplug.com
tip is firmly pressed against the fixture. If the tool is not
properly pressed against the surface of the fixture, the
nail may be fixed incorrectly or not fixed at all.
- If the nail becomes jammed inside the tool,
disconnect it from the battery and remove the gas
container. When connected to a power source, the
nailer may accidentally start up while a jammed nail
is being removed.
- Do not use the nailer to directly fix electrical
installations. This device is not intended for
mounting electrical cables and may damage their
insulation, thus posing a risk of fire, electric shock or
damage to the electrical system.
- Periodic maintenance and servicing will ensure
long and trouble-free operation of the tool. No
modifications of the power tool are allowed. All
modifications performed outside the service centre
reduce the level of safety and may adversely affect
the operation of the device, additionally invalidating
its warranty.
Regardless of material specifications, always
perform fixing tests to select the right nails
and to set the tool parameters correctly. Do not
operate the device with your wrists or elbow joints
locked. The device may recoil causing an injury.
- Do not fix in substrates that are not thick enough,
or too close to edges. This may cause the substrate
to chip off and cause an injury.
- Use only the lubricants recommended by the
manufacturer. The tool does not require daily
external lubrication. The tool should be lubricated
only when it is being cleaned or maintained.
- Keep the tool clean and wipe off grease or oil after
use. Do not use solvent-based cleaning agents to
clean the tool. Solvents may reduce the strength of
the tool's rubber and plastic parts. A greasy grip or
body of the tool may cause accidental dropping and
injury to the operator or bystanders.
Recommended nails and accessories:
- Use only the nails recommended by the
manufacturer, or ones whose parameters correspond
to the nails recommended by the manufacturer.
- Use only the accessories recommended by the
manufacturer.
Notes: Accessories included: 2 batteries, charger and
charger power cord.
- Use the tool for its intended purpose only. In
particular, do not use the tool as a hammer, as the
impact force increases the risk of damage to the tool
EN EN
body and accidental nail ejection.
- Charge the tool with nails last in order to prevent
accidental ejection while installing the gas cartridge
and the battery pack.
Controls:
- Do not use the tool if the warning labels are missing
or damaged.
- Do not use a tool that is not in good technical
condition.
- Do not remove or modify the controls or make
them inoperable in any way.
- Do not use the tool if any of its controls are
inoperable, disconnected, modified, or do function
improperly.
Tool handling:
- The tool should only be used by persons who have
read and understood the contents of the operation
manual/safety instructions.
- Always assume that the tool contains nails, and that
it is ready for operation.
Do not aim the tool at yourself or anyone else,
regardless of whether or not it contains nails!
Work in
operated, the device produces carbon
monoxide which dangerous to human health.
Do not touch the exhaust outlet. The device
heats up during operation. Hold the device by
the grip only.
- Do not use the tool in the presence of children or
bystanders.
- Before pulling the trigger, make sure that the tool's
tip is firmly pressed against the base material.
- The tool should be treated as an aid to work.
- Stay vigilant, focus on the job at hand and maintain
common sense when using the tool.
- Users who are tired or affected by drugs, alcohol or
medication must not use the tool.
- Avoid working in an excessively tilted position. Keep
your balance at all times.
- Do not hold or carry the tool while holding your
finger on the trigger.
- Nails should only be driven into a suitable working
surface.
- After a nail has been driven in, the tool can recoil,
consequently moving abruptly in the direction
opposite to the working surface.
In order to reduce the risk of injury, contain the
recoil by:
- maintaining ongoing control of the tool,
- allowing the recoiling tool to move away from the
working surface,
- not resisting the recoil force by pushing the tool
back against the working surface,
- keeping face and body parts away from tool.
- When working close to the fixture edge or driving
at a sharp angle, take special precautions to minimise
chipping, splitting, ricocheting or unintended
ejection of nails, which can lead to injury.
- Keep your hands and other body parts away from
the tool's muzzle.
- Do not operate the tool with a power source that
does not comply with the specifications provided in
the tool's operation manual/safety instructions.
- Take special precautions when driving nails into
existing walls or other substrates that restrict
visibility in order to avoid injuring people on the other
side or damaging hidden objects (e.g. pipes, cables).
Remove the gas cartridge and the battery pack
from the tool when it is not in use as well as in
the following cases:
The tool is being maintained or repaired;
well-ventilated places. When - A jammed item is being removed from the tool;
- The tool is being lifted, lowered or otherwise
moved to a new position;
- The tool is not supervised or operated by a
competent operator;
- Nails are being removed from the magazine.
WARNINGS FOR GAS CONTAINER HANDLING
ƒ Use only gas containers recommended by the
manufacturer.
ƒ Recycle used-up containers in accordance with
the applicable local regulations.
ƒ Do not attempt to recharge or incinerate an
empty gas container.
ƒ Do not expose the gas container or a tool with
the gas container installed to direct sunlight.
Avoid storing the aforementioned items at
temperatures above 50°C (120°F).
ƒ Overheating of the gas container can lead to an
explosion or fire.
ƒ Do not pierce or attempt to open the gas
container. It contains flammable gas, even when
it seems empty.
ƒ The contents of the gas container are highly flammab-
le. Keep it away from any heat or ignition sources.
Notes: Recommended gas container: R-RAWL-GP6.
WW90 II
17
www.rawlplug.com