Publicité
Assembly - Hanging the Fan (continued)
6
Mounting the fan-motor assembly (standard mount)
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Align the locking slots of the canopy (C) with the two screws (HH)
in the mounting bracket (A). Push up to engage the slots and turn
clockwise to lock in place.
□
Firmly tighten the two mounting screws (HH).
□
Install the two canopy screws (II)(saved from Assembly Step 1
"Prepairing for mounting") into the holes in the canopy (C) and
tighten firmly.
□
Install the decorative canopy ring (JJ) by aligning the ring's slots
with the screws in the canopy (C). Rotate the ring clockwise to lock
in place.
7
Mounting the fan-motor assembly
(close-to-ceiling mount)
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Carefully unhook the fan from the mounting bracket (A) and align
the locking slots of the ceiling canopy (C) with the two screws in
the mounting bracket (A). Push up to engage the slots and turn
clockwise to lock in place. Immediately tighten the two mounting
screws firmly.
□
Install the two mounting screws (II) (saved from Assembly Step
1 "Preparing for mounting") into the holes in the canopy (C) and
tighten firmly.
□
Install the decorative canopy ring (JJ) by aligning the ring's slots
with the screws in the canopy (C). Rotate the ring clockwise to
lock in place.
□
You may now proceed to attaching the fan blades.
A
II
A
II
11
Please contact 1-855-HD-HAMPTON for further assistance.
HH
JJ
C
E
JJ
C
E
HOMEDEPOT.CA
Publicité
