Publicité
[EN]
4
ASSEMBLY
Please note: The shells and padding are "right" and "left" specific (see label on the comfort
padding).
B
The remaining parts can be attached interchangeably to the right or left spurs.
1
You'll need a set of Torx keys:
T45
T40
T30
• Place the shell on the shank, making sure there is approximately 5 cm between your
kneecap and the top of the shell (tip: two to three finger widths).
C
• Attach the two M6x14 screws through the shell holes provided (4 Nm tightening torque;
1
T30 Torx key).
• Adjust the height from 42 to 48 cm by 2 cm increments.
• Place the protective padding on the corresponding shell (pay attention to right and left),
folding it slightly. The padding comes with a flap to position behind the shell. Centre it
on the shell: the FTC marking must be on the front. Once properly in place, press lightly
so that the Velcro sticks to the padding.
D
• Adjust the position of the leg strap between the two sides of the padding/shell assembly
by lifting the preset clip and sliding the protection onto the fixed strap. Lock by lowering
the clip after adjusting.
• Leave the gaff covers on when assembling.
• Turn one strap so that the micrometric buckle is towards the front of the foot.
Install the foot support strap by inserting the D ring into the groove as shown in the illus-
tration. Fix the flange button head screw M8x12 (10 Nm tightening torque; T40 Torx key)
to lock the ring in the groove.
E
• Slip the strap under the gaff. Screw in the gaff with the upper screw M8x20 and the lower
screw M8x25 (10 Nm tightening torque; T45 Torx key).
• The grips are sold separately and can be used or not according to the way you work and
each situation.
Grip assembly (optional): Attach the grips using the M8x16 screws ( 10 Nm tightening
torque; T45 Torx key).
P. 20
M8 (gaffs, grips)
M8 (lower straps)
M6 (shells)
Publicité
