Publicité
HEATER BACK
FIG.2
ZBTT30 SERIES
lgnition
Hole
Tip-over
Switch
Inlet
Connector
Heat Regulator
Valve
Fuel Connecting
Nut(Handle)
Reverse Thread
To Tighten: Turn Counterclockwise
FIG.3
ZBTT15 SERIES
Burner
Ignition Hole
Safety Shut-off Valve
Heat Regulator Valve
16
Flame Sensors
lgnition Hole
SafetyShut-off
Valves
Tank Collar
Bracket
Propane Tank Valve
HEATER FRONT
Burner
Guard
Flame Sensor
Tip-over Switch
Wing Bolt
Support Bracket
Checking for Leaks
Check all gas connections with a 50/50 mix of liquid dish soap and
water solution to be sure they are tight and leak proof. The
formation of bubbles indicates a gas leak.
Correct all leaks before using the heater.
▪ The installation of your heater must meet all local codes and/or
gas utility requirements or, in the absence of local codes, the
storage and handling of liquefied petroleum gases, ANSI/NFPA 58
and the natural and propane installation code, CSA B149.1.
▪ Always maintain proper clearance from combustible materials.
Minimum clearance from combustible; side & rear:36'' (91cm); Top:
36'' (91cm); Front: 59''(150cm); Floor: 0'' when installed on 20lb.
Tank.
▪ The hose assembly should be visually inspected prior to each use
of the heater. If it is evident that there is excessive abrasion or
wear, or the hose is cut, it must be replaced prior to the heater
being put into operation. The replacement hose assembly must be
the exact replacement.
WARNING: NEVER USE AN OPEN FLAME TO CHECK FOR
LEAKS.
Operation-lighting Instructions
Read and understand all safety information before operating heater.
WARNING:
▪ Burner and burner guard should always face away from propane
tank shutoff and regulator.
▪ Improper installation, alteration, service or maintenance can
cause property damage, injury or death. Read the installation,
operating and maintenance instructions thoroughly before installing
or servicing this equipment.
17
Publicité
