EN
General
Guidelines
Please read the following instruction carefully
and use the product accordingly.
Please keep this manual and hand it over
when you transfer the product.
This summary may not include every detail
of all variations and considered steps.
Please contact us when further information
and help are needed.
Warnings
This product must be fixed to the wall tightly
to avoid personal injury caused by falling/tilting.
Check and make sure it is securely anchored
before use.
Always securely fix the item to the wall for usage.
It is not intended for use by children under 5
years of age. Children must be under adult
supervision to use the product.
It is forbidden children to climb or play on the
product to avoid serious body injury caused by
the toppling.
During the assembly process, keep any small
parts out of the reach of children. It may be fatal
if swallowed or inhaled.
To avoid the potential dangers of suffocation,
please keep all parts and packaging (films,
plastic bags and foam, etc.) away from babies
and children.
Notes
This item is only intended to be used indoors. Personal injury and/or damage to product
may occur if products are used outside of their intended purposes and/or if products have
been changed/modified from their original design. The product must be assembled and
used in accordance with the provisions of the manual. The seller does not assume any
responsibility or liability with respect to any damage caused by incorrect assembly or
improper use.
It is recommended that assembly is undertaken by at least 2 adults. Please read assembly
instructions before assembly and strictly adhere to each step outlined.
If there is/are defective and/or missing part/s after unpacking, please cease assembly
immediately and get in contact with us.
Please assemble the item in a spacious room and do not place the unwrapped product
directly on the ground to avoid damage. It is recommended to wear gloves during the
assembly to avoid scratches from any sharp edges.
Please do not stand, sit or place heavy items on the wooden boards or other parts before
assembly to avoid the cracks or distortion of the wooden boards. Cracks or distortion will
affect the assembly and normal use.
Please match the corresponding board and fitting based on the part number in the manual.
If the board does not match with the fitting, please check the pieces as specified in
this manual.
Please refer to the diagram during assembly. Align all screws with the related pre-drilled
holes first and later tighten the screws one by one only after putting all the parts in
their correct places.
Please note that some types of parts have a spare.
Use electric drill for punching holes in the wall. Carefully measure the distance between
the two holes and keep them level.
Periodically inspect screw tightness while the product is in use. If necessary, retighten
to ensure structural integrity.
Do not expose product to direct sunlight exposure or rain. Never touch with sharp
objects or corrosive chemicals, which may damage the surface of the item.
For daily care, please clean with a damp cloth then immediately wipe dry.
13