Publicité
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Wiring configuration
Power supply. wire:
Terminal box wire:
white ~«<——- white
black <«¢——-»- black
ground wire ~«——_» ground connector
If needed, see website for animated representation of this step.
Visit www.jenn-air.com/electrical under FAQ tab.
4 | Direct Wire—Secure cable
-—
in strain relief
Tighten strain relief screws to secure cable.
Direct Wire—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 14" nut driver or Torx® T20® screwdriver
and previously removed screw to secure cover.
Double-check dishwasher
alignment in cabinet opening
Check that dishwasher is still level front-to-back and side-to-side
in cabinet opening.
Remove
lower dish rack
and place towe
©
WEES
wa a
Open dishwasher door, remove lower dish rack, and place towel
over pump assembly and lower spray arm of dishwasher. This will
keep screws from falling into pump area when you are securing
dishwasher to countertop.
3}
Secure dishwasher
'
=
\ \
screw to
side cabi
NOTES:
m
Donot drop screws into bottom of dishwasher.
g_
If side mounting, you must drill pilot holes in cabinet to avoid
splitting the wood before installing screws. Locate brackets
on top of dishwasher and secure dishwasher to countertop
with two #10 x 4%" Phillips-head screws (included). The
dishwasher must be secured to keep it from shifting when
door is opened.
21
Publicité
