Publicité
Door falls open —
Increase spring tension
When door is unlatched and door opens by itself, move the
tensioner to a lower numbered hole and replace the screw.
Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should be secured
at same holes.
Move dishwasher into
cabinet opening
Kv
Insulation
blanket
IMPORTANT:
If wheels were removed,
cover the floor when
moving the dishwasher to avoid damage to the floor. Slowly move
dishwasher completely into cabinet opening. Do not kink or pinch
water line, drain hose, power supply cord or direct wire between
dishwasher and cabinet. Remove cardboard from under
dishwasher.
NOTES:
g_ = Itis all right if dishwasher fits tightly into cabinet opening. Do
not remove insulation blanket — the blanket reduces the sound
level.
m_
If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
8
Align front of dishwasher
with front of cabinet doors
oN
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your cabinets.
18
Check for plumb and
if needed
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check that
dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using the %s6" hex head socket or
adjustable wrench.
Preferred method
Optional method
Check level side-to-side and
adjust legs if needed
7 {
' i
Ss
SS
| i [-
'
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Publicité
