Publicité
ENGLISH
STEP 3. PHOTOTHERAPY MASSAGER
-
Press and hold the power and mode change button to switch the appliance on. When
the appliance is switched on, the Clean mode and the low intensity level are activated by
default. Press the power and mode change button to select the desired mode. The order
of selection is as follows: "Clean mode" - "Brighten mode" - "Boost mode" - "Moist mode".
-
This appliance has 2 adjustable intensity levels: low and high. It also has a heat function.
In the low intensity level, the temperature is 38 °C, and in the high intensity level it is 42 °C
(only Brighten, Boost and Moist modes have a built-in heat function).
-
When you have finished using the massager, switch it off. Press and hold the power and
mode change button to switch the appliance off.
-
Each mode has an automatic timer of 3 minutes.
Clean mode
-
Remove all make-up and dirt from your face.
-
Remove the magnetic fixing ring from the appliance, place a cotton pad on the massage
head and put the ring back in place.
-
Soak the cotton pad well with facial toner.
-
Press and hold the power and mode change button to switch the appliance on and activate
the Clean mode. Select the intensity level according to your skin's needs.
-
Hold the appliance with one hand and be sure to touch the sensors on both sides. Gently
press the massage head onto the face. The appliance will start to vibrate slightly. Glide the
appliance from the centre of the face outwards in a circular motion to deeply cleanse the
pores and remove dirt from the skin. Remove the cotton pad from the appliance after use.
-
Use Clean mode 2-3 times a week for 3 minutes for best results.
-
Face area and recommended order of use: T-zone (forehead and nose), cheeks and chin.
-
After using the appliance, rinse your face with water and follow the steps of your daily
facial routine.
Brighten mode
-
Use this mode after removing make-up or after using the Clean mode.
-
Switch on the appliance and select the Brighten mode. Select the intensity level according
to your skin's needs.
-
Hold the appliance with one hand and be sure to touch the sensors on both sides. Place
the massage head 2-3 cm away from the face and expose the skin to the LED light evenly.
When using this mode, close your eyes to avoid discomfort.
-
Use the Brighten mode once a day for 3 minutes for best results.
-
Face area and recommended order of use: T-zone (forehead and nose), cheeks and chin.
-
After using the appliance, follow the steps of your daily facial routine.
Boost mode
-
Use this mode after removing make-up or after using the Clean or Brighten mode.
52
FACECARE SKINROUTINE
Publicité
