Publicité
ENGLISH
PHOTOTHERAPY MASSAGER: when the battery is running low, the high and low
C.
intensity levels indicator lights will flash 3 times and the appliance will automatically
switch off. During charging, the high and low intensity levels indicators will flash at
the same time. When charging is complete, the indicator lights will remain steady.
The appliance takes about 3 hours to fully charge.
Warning: do not attempt to replace the battery in any of the appliances.
3.2. Use modes
STEP 1. FACIAL CLEANSER
-
Press the power button to switch the appliance on. Then, adjust the intensity level of
cleansing using the -/+ buttons according to your skin type and needs.
-
The appliance will automatically switch off after 90 seconds of inactivity. If you want to
switch it off manually before this time has elapsed, press the power button again.
Deep pore cleansing
-
Moisten the skin with lukewarm water. Apply a small amount of facial cleanser to your
hands and rub them gently into foam.
-
Apply the foam to your face and glide the silicone cleansing surface from the centre
outwards in a circular motion to thoroughly cleanse pores.
-
Face area, order and recommended time of use: T-zone (forehead, nose): 20 seconds;
cheeks: 15 seconds each (30 seconds in total); chin: 10 seconds; neck: 30 seconds.
Exfoliation
-
Moisten the skin with lukewarm water. Apply a small amount of facial cleanser to your
hands and rub them gently into foam.
-
Apply the foam to your face and glide the exfoliating silicone surface from the centre
outwards in circular motions to exfoliate the skin.
-
Face area, order and recommended time of use: T-zone (forehead, nose): 20 seconds;
cheeks: 15 seconds each (30 seconds in total); chin: 10 seconds; neck: 30 seconds.
-
For sensitive skin, it is recommended to use the exfoliating silicone surface once a week.
For normal, mixed or oily skin, you can use it according to your skin's needs.
-
Always switch off the appliance after use. Next, rinse and dry your face and then apply
moisturiser.
STEP 2. ANTI-DARK CIRCLES MASSAGER
Buttons
1. Press and hold the power and mode change button to switch the appliance on or off.
2. Press the power and mode change button to select the desired mode and set the intensity
level. Each mode has 3 adjustable intensity levels. The order of selection is as follows:
"Massage mode level 1" - "Massage mode level 2" - "Massage mode level 3" - "Lift mode
50
FACECARE SKINROUTINE
Publicité
