Metabo HPT M 3612DA Instructions De Sécurité Et Mode D'emploi page 18

English
1. Switch operation
This product is equipped with an ON/OFF Lock button
to prevent any inadvertent switch trigger operation. To
activate the tool, press down on the ON/OFF Lock
button and draw the switch trigger. (Fig. 26)
When the switch trigger is fully drawn,
press of the ON/OFF Lock button will lock the switch
trigger in place, allowing the release of the switch
trigger for continued operation. (Fig. 27 (a))
The switch trigger will not be locked if the ON/OFF
Lock button is released before the switch trigger is
fully drawn, making it possible to operate the tool with
a press of the switch trigger.
To unlock the switch trigger, draw the switch trigger
once again to release the ON/OFF Lock button and
discontinue operation. (Fig. 27 (b))
Prior to using the tool, make sure that the ON/OFF
Lock button and the switch trigger are operating
properly.
(a)
18
ON/OFF
Lock button
Switch
trigger
Fig. 26
a further
(b)
Fig. 27
2. How to use the LED light (Fig. 28)
The LED light will light the area at the tip of the tool
when the switch is "ON".
The LED light will automatically power off 10 seconds
after the switch is released.
ON/OFF
Lock button
Switch
trigger
LED light
CAUTION
Do not look directly into the light from the LED
lamp. Continuous and direct exposure to the
light from the LED lamp can injure your eyes.
3. Adjusting the rotation speed
The M3612DA has an electronic control system
that allows rpm changes. As shown in Fig. 29, dial
position "1" is for minimum speed, and position "6" for
maximum speed.
4. Cutting Operation
CAUTION
When processing the side of a material, make
sure that the side to be processed is on the left
of the bit in the direction that the material is fed.
Placing the side to be processed on the right of
the bit goes counter to the bit's revolution and
may cause the motor to stop. Too much load in
such cases may result in malfunction.
Fig. 28
Dial
Fig. 29