Metabo HPT M 3612DA Instructions De Sécurité Et Mode D'emploi page 17

<Straight guide>
Use straight guide for chamfering and groove cutting
along the materials side. (Fig. 22)
Wing bolt (A)
Guide plane
Guide bar
Straight guide
(1) Insert a guide bar into each hole in the bar holder, then
lightly tighten the 2 wing bolts (A) on top of the bar
holder.
(2) Insert a guide bar into each hole in the base, then fi rmly
tighten the wing bolts (A) (standard accessories).
(3) Make minute adjustments of the dimensions between
the bit and the guide surface with the feed screw, then
fi rmly tighten the 2 wing bolts (A) on top of the bar
holder and the wing bolt (B) that secures the straight
guide.
(4) As shown in Fig. 23, securely attach the bottom of the
base to processed surface of the materials. Feed the
router while keeping the guide plane on the surface of
the materials.
NOTE
When using the straight guide, be sure to install it on
the right side in the feed direction. This will help to
keep it fl ush with the side of the workpiece.
<Dust Collector Set>
Connect the dust collector set cleaner to collect dust.
(1) Mounting the dust collector.
Use a screwdriver to attach the two screws to the
base. (Fig. 24)
Wing bolt (A)
Bar holder
Feed screw
Wing bolt (B)
Fig. 22
Fig. 23
Align the holes on the dust collector with the two
screws and attach the dust collector.
Tighten the two knob nuts.
Connect the cleaner to the dust collector. (Fig. 25)
Hose (Cleaner)
(2) Dismounting the dust collector.
Use a screwdriver to loosen the two screws.
OPERATION
WARNING
● To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
● Wear eye protection when operating this tool.
● Keep your hands, face and other body parts
away from the bits and any other rotating parts,
while operating the tool.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Pull out the battery after completing operation.
English
Dust Collector
Knob nut
Screw
Fig. 24
Dust Collector
Fig. 25
17