Publicité
CONNECTION
- Before making any connections, make sure that all equipment is switched off and disconnected from the
power supply.
- Check that all volume controls for each channel and for the MAIN MIX output are set to minimum.
- Connect the desired devices to the input channels and select the input type on the CH 1 and CH 2
channels.
- If you want to use the player, connect a USB device or connect a device via Bluetooth connection and
select PLAYER on the front panel of CH 3.
- Connect the MAIN MIX output to a level input of a power amplifier.
- Connect the equipment to the power supply. Switch on the equipment in this order: peripheral equipment,
followed by the MIX-3DJ mixer and lastly the power amplifier (if necessary).
- Adjust the volume of each channel with the VOL. controls.
BLOCK DIAGRAM
PHONO/LINE
CH 1
PHONO/LINE
CH 2
LINE
CH 3
PLAYER
+ USB
MIC
MIC
UNBALANCED
AMPLIFIER
CUE
FADER
CH 1
PHONO/LINE
FADER
CH 2
PHONO/LINE
PLAYER/LINE
FADER
CH 3
VOL
MIC
PLAYER
-15dB
-15dB
TALK OVER
ON
-15dB
OFF
- 5 -
VUMETER
MAIN MIX
L/R
CUE SELECT
VOL
CUE L/R
CUE
EN
Publicité
