Publicité
Operating Instructions
Control Panel Features
Setting
indicator light
Timer
indicator light
F
ig.5
Buttons
When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
Power Pad
1
Press to turn the dehumidifier on and off.
NOTE: When the compressor startups or stops
running, the unit may make a loud voice, it is normal.
Mode Pad
2
Press to select the desired operation mode from
Dehumidifying,Dryer,Continuous dehumidifying and
Smart dehumidifying.
NOTE: Dryer and Smart dehumidifying modes are
optional.
3
4
: Up/Down Pads
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the
percent value(%).
For damper air, press the
percent value(%).
Timer Pad
5
Press to initiate the Auto start and Auto stop
feature, in conjuction with the
TIMER Set Control Pads
Use the Up/Down pads to set the Auto start and
Auto stop time from 0.0 to 24.
Smart dehumidifying
operation on indicator
light
Continuous
Dryer operation
operation on
on indicator light
indicator light
2
4
5
pad and set to a lower
pad and set a higher
and
pads.
Fan speed
Fan speed
indicator light
indicator light
3
9
5
7
6
Fan Pad
Control the fan speed. Press to select
fan speed in three steps-low, med and
high. The fan speed indicator light
illuminates under different fan speed
settings. But when select high fan speed,
both the low and med fan speed lights
illuminate.
Clean filter Pad
7
Press this pad for 3 seconds to initiate the reset
the filter cleaning reminder.
Wireless Pad
8
Press this pad for 3 seconds to initiate the
Wireless connection mode. The LED DISPLAY
shows 'AP' (at this time the unit shuts off all other
functions) to indicate you can set Wireless
connection. If connection(router) is successful
within 8 minutes, the unit will exit Wireless
connection mode automatically and the Wireless
indicator illuminates and the unit enters the
previous functions. If connection is failure within
8 minutes, the unit exits the Wireless connection
mode automatically.
Display
9
Shows the set % humidity level from 35% to 85% or
auto start/stop time (0~24) while setting, then shows
the actual (¡5% accuracy) room % humidity level
in a range of 30%RH(Relative Humidity) to 90%RH
(Relative Humidity).
30
Clean filter indicator light
Wireless operation
on indicator light
1
8
Publicité
