Table des Matières
Publicité
Liens rapides
INSTRUCTION MANUAL - GUIDE D'INSTALLATION
N006
shower door - porte de douche
2 PEOPLE REQUIRED
2 PERSONNES REQUIS
IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF THE
SHOWER UNIT TO SECURELY FASTEN THE RAIL TO THE WALLS.
IL EST OBLIGATOIRE D'AVOIR UNE OSSATURE MURALE SUR CHAQUE
CÔTÉ DE LA DOUCHE POUR FIXER LA BARRE DE ROULEMENT.
Publicité
Table des Matières
Manuels Connexes pour Novara N006
Sommaire des Matières pour Novara N006
- Page 1 INSTRUCTION MANUAL - GUIDE D’INSTALLATION N006 shower door - porte de douche 2 PEOPLE REQUIRED 2 PERSONNES REQUIS IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF THE SHOWER UNIT TO SECURELY FASTEN THE RAIL TO THE WALLS.
-
Page 2: General Instructions
INSTRUCTION MANUAL - GUIDE D’INSTALLATION GeNerAL INsTrUCTIoNs • read this manual carefully and completely before proceeding. • It is recommended that you wear safety glasses at all times during the installation. INsTALLATIoN oVer CerAMIC TILes • If your shower door is to be installed over ceramic tiles, the tiles should lie completely under the wall jamb. •... -
Page 3: Tools And Material Required / Outils Et Materiaux Requis
INSTRUCTION MANUAL - GUIDE D’INSTALLATION TOOLS ANd MATeRIAL ReQUIRed / OUTILS ET MATERIAUX REQUIS LoNG Nose LoCKING PLIers sCrewdrIVers drILL pINCe Serre étau tourNevIS perCeuSe PeNCIL 1/4" & 1/8" drILL bITs sILICoNe CraYoN MÈCHE 1/4˝ & 1/8" SCeLLaNt CUTTING PLIers LeVeL TAPe MeAsUre pINCe CoupaNte... -
Page 4: Parts Listing / Liste Des Pièces
INSTRUCTION MANUAL - GUIDE D’INSTALLATION PARTS LISTINg / LISTE DES PIÈCES hArdwAre / quINCaILLerIe ITEM PARTS - PIÈCES WaLL JamB (reguLar puNCh) - JamBage (perÇage réguLIer) FIxeD paNeL - paNNeau FIxe uNIverSaL expaNDer - exteNSeur uNIverSeL FIxeD paNeL gaSKet - JoINt D’étaNChéIté paNNeau FIxe mIDgaSKet - JoINt LateraL Door paNeL - paNNeau De porte Bottom Door gaSKet - JoINt INFérIeur... -
Page 5: Vue Latérale
INSTRUCTION MANUAL - GUIDE D’INSTALLATION POSSIbLe CONfIgURATIONS / CONFIGURATIONS POSSIBLES recommended door panel according to showerhead location. Choose right or left door opening, according to recomandations. Trace a centerline on the threshold of the base, making sure the bottom guide can be positioned as shown below. determine on which side the wall jamb will be mounted. -
Page 6: Épaisseur Minimum Orientée Vers Le Bas
INSTRUCTION MANUAL - GUIDE D’INSTALLATION VvVV dOOR PANeL ASSeMbLy / ASSEMBLAGE DE LA PORTE COULISSANTE Use a mallet to install the bottom gasket (7) on the bottom of the door panel (6). To DOOR HANDLE HOLES facilitate installation, place the door panel on trouS de poGNer de porteS the cardboard packaging box and use it as platform. -
Page 7: Running Rail / Barre De Roulement
INSTRUCTION MANUAL - GUIDE D’INSTALLATION dOOR PANeL ASSeMbLy (CONTINUed) / ASSEMBLAGE DE LA PORTE COULISSANTE (SUITE) Place door panel (6) inside the shower area to simplify the following installation procedures. Place the panel on a cushioned surface, such as a towel or carboard, to prevent damage either to the panel or to the base. - Page 8 INSTRUCTION MANUAL - GUIDE D’INSTALLATION fIXed PANeL ASSeMbLy / ASSEMBLAGE DU PANNEAU FIXE Assemble the fixed panel with the running rail. Align running rail holes with the holes of the fixed panel. Install glass fasteners(19) to join the fixed panel(2) and the running rail (9). Be sure to place gaskets between all contact with glass and metal parts. Fasten with 3mm hex key.
- Page 9 INSTRUCTION MANUAL - GUIDE D’INSTALLATION fIXed PANeL ASSeMbLy (CONTINUed) / ASSEMBLAGE DU PANNEAU FIXE (SUITE) Place “U”-channel (12) temporarily on the bottom of the fixed panel (2). Slide the pre-assembled fixed panel (2) with expander (3) and gasket (4) into the wall jamb (1). Level the glass panel assembly with the wall jamb. Temporarily reassemble the angled wall back plate to the wall brackets on the running rail.
- Page 10 INSTRUCTION MANUAL - GUIDE D’INSTALLATION fIXed PANeL ASSeMbLy (CONTINUed) / ASSEMBLAGE DU PANNEAU FIXE (SUITE) Temporarily place the fixed panel assembly on the threshold of the base on the line that was marked previously. Push wall brackets against the wall (x2) and level. Trace the outer edges of the wall brackets (x2).
- Page 11 INSTRUCTION MANUAL - GUIDE D’INSTALLATION wALL jAMb INSTALATION / INSTALLATION DE JAMBAGE Push the wall jamb against the wall. Level the glass panel assembly with the wall jamb. Lock into position by clamping the wall jamb and expander with pliers. Trace the position of the wall jamb on the wall as illustrated. Pousser le jambage contre le mur.
- Page 12 INSTRUCTION MANUAL - GUIDE D’INSTALLATION wALL jAMb INSTALATION (CONTINUed) / INSTALLATION DES JAMBAGES (SUITE) Trace the position of the “U”-channel (12) and of the bottom guide (17) on the threshold of the base. Mark the location of the bottom guide’s hole. Remove the fixed panel assembly with the running rail along with the wall jamb , wall brackets the “U”-channel and the bottom guide.
- Page 13 INSTRUCTION MANUAL - GUIDE D’INSTALLATION wALL jAMb INSTALATION (CONTINUed) / INSTALLATION DES JAMBAGES (SUITE) Place the wall jamb against wall using the line previously marked as a guide. Level and mark locations of the four holes INTerIor to be drilled. remove the wall jamb. shower sIde INtérIeur De drill a hole in each location with a 1/4"...
- Page 14 INSTRUCTION MANUAL - GUIDE D’INSTALLATION wALL jAMb INSTALATION (CONTINUed) / INSTALLATION DES JAMBAGES (SUITE) Add silicone to the exterior bottom edge of the wall jamb. Fasten the wall jamb to the wall with 1-1/4" screws (24) through the previ- ously installed wall plugs. (x4) Add silicone to interior bottom edge of the wall jamb.
- Page 15 INSTRUCTION MANUAL - GUIDE D’INSTALLATION wALL bRACkeT bACk PLATe (CONTINUed) / PLAQUETTE ARRIERE DU SUPPORT MURAL (SUITE) Insert one drop of silicone in each hole bored in the wall before inserting the wall plugs. Screw in flat head screws through holes to secure back plate of bracket to wall (x2) Introduire une goute de silicone dans chaque trou percé...
- Page 16 INSTRUCTION MANUAL - GUIDE D’INSTALLATION bOTTOM gUIde INSTALLATION / INSTALLATION DU GUIDE DU BAS Place bottom guide to the edge of the “U”-channel .Center the front bottom guide channel to the center of the “U”-Channel. once in place, mark hole location and remove bottom guide. drill with 1/8"...
- Page 17 INSTRUCTION MANUAL - GUIDE D’INSTALLATION fIXed PANeL INSTALLATION / INSTALLATION DU PANNEAU FIXE Install the fixed panel. Insert the running rail into the wall bracket back plates that were installed previously. Insert the glass panel in the front bottom guide channel. Push wall brackets towards the wall and lock in with the back plates previously secured to the wall.
-
Page 18: Secure The Wall Jamb And Expander / Securiser Le Jambage
INSTRUCTION MANUAL - GUIDE D’INSTALLATION SeCURe The wALL jAMb ANd eXPANdeR / SECURISER LE JAMBAGE drill a hole through the wall jamb with a 1/8" drill bit, to pierce through the expander. (x3) Screw 3/4" screws (23) through holes to hold expander and wall jamb together in place. - Page 19 INSTRUCTION MANUAL - GUIDE D’INSTALLATION dOOR gASkeTS INSTALLATION / INSTALLATION DES JOINTS AU PANNEAU DE PORTE Temporarily install midgasket (5) and the door gasket (8) to door panel. Close door entirely, mark interference of the gaskets with the running rail. Cut gasket at marked locations using cutters.
-
Page 20: Anti-Jump & Door Stopper / Anti-Saut & Butoir
INSTRUCTION MANUAL - GUIDE D’INSTALLATION ANTI-jUMP & dOOR STOPPeR / ANTI-SAUT & BUTOIR Install anti-jump (14) in lower holes of door panel located below the running rail. be sure to place gaskets between contact of glass and alumini- um parts. (x2) Install door stopper (16) located in the interior shower next to wall jamb. -
Page 21: Threshold / Seuil De Rétention
INSTRUCTION MANUAL - GUIDE D’INSTALLATION 13 dOOR ReCeIveR INTALLATION / INSTALLATION RÉCEPTRICE DE PORTE Place door receiver (15) against the wall, so that the door panel slides smoothly into the receiver. Mark hole location. remove door receiver and drill in marked location with 1/8”... - Page 22 INSTRUCTION MANUAL - GUIDE D’INSTALLATION SeALINg / CALFEUTRAGE Silicone the outside of the shower unit along the wall jamb and the exterior side of aluminum threshold and “U”-channel. Wait 24 hours before using the shower to allow silicon to dry. Calfeutrer avec du silicone l’extérieur de l’unité...