Publicité
Marking and labeling
The following diagrams provide important information about this product and the protection it provides.
Cleaning
Always follow the washing instructions printed on the label attached to the garments, since when alternative
fabrics with specific performance characteristics are used, washing instructions may differ. Touch-and-close
fastenings, where fitted, can be cleared of debris using a nail brush. If the protector components have become
soiled in use, wipe the surface with a damp cloth. Use a soft brush, damped in water, to clean the perforations
in the components. Only use tap water. Never use cleaners or detergents, or launder the protector, the
product will be damaged by the cleaning process and chemicals and the level of protection provided severely
reduced.
Common substances applied to this product (solvent, cleaners, hair tonics, etc.) can cause damage that may
be invisible to the user and compromise the effectiveness/safety of your Leatt ® product. If in any doubt,
please contact the manufacturer before cleaning or laundering your protector. Always refer to the material
content label on the Leatt ® product. None of the materials used in the construction of the product are known
to contain anything that is harmful or might cause an allergic reaction or be dangerous to health.
Storage and transportation
Place the Leatt ® product on a clean, dry surface and store in a dry, well-ventilated environment away from
direct sunlight and extreme temperature. Do not place heavy objects on top of Leatt ® product as this can
damage the fabrics and plastic materials. The protection provided by your Leatt ® product should not be
affected by non-extreme ambient temperature and weather conditions.
Maintenance and obsolescence
For maximum performance, the Leatt ® product must be inspected prior to each use. Stop using the protector
if any components show signs of damage or are worn, cracked, and/or deformed, or if the inside padding
has deteriorated. Leatt ® Corporation recommends that the Leatt ® product is replaced every three (3) years
6
The "CE " mark denotes
compliance with the health and
safety requirements of Annex
II of the Personal Protective
Equipment Regulation (EU)
2016/425.
The recommendation to
read the manufacturer's
instructions contained in
this booklet
No bleach
Do not
tumble dry
Wash
zodlmU
No
Dry in
Do not
shade
Denotes that the product
is or incorporates a chest
protector which meets
European Standard EN
14021:2003
Denotes that the product
is or incorporates a central
back protector ("CB") which
meets Level 1 of European
Standard EN 1621-2:2014
1
No
iron
solvents
Copyright © 2023, Leatt ® Corporation
Publicité
