Publicité
Problem
Probable cause(s)
Suggested remedy
Page(s)
Common Problems
Unit doesn't come on.
The power cord plug is not fully inserted.
• Confirm the plug is fully inserted.
-
Sound is not heard.
The speaker indicators are off.
• Turn on the speaker indicators.
22
The tape monitor function is on.
• Press the tape monitor button.
24
The muting function is on.
• Press the muting button on the remote
control.
33
Incomplete
or
incorrect
connection
to
speakers and external equipment.
• Check all connections.
10-16
The
incorrect
input
source
has
been
selected.
• Select the correct source.
22
Digital signals this unit cannot decode are
being played.
• Either have the player convert the signals,
so this unit can handle them or switch to
ANALOG input.
22-23
Cannot play CD, DVD, or
TV.
The DIGITAL input mode is set to DIGITAL
or ANALOG.
• Change the setting to suit the type of
connection you have made.
22
Nothing appears on the
display.
VGCA is ON.
• Nothing
appears on
the
display while
VGCA is on. To turn the display on, press
and hold [VGCA].
27
The display is dim.
The dimmer is on.
• Press [DIMMER] to restore the display to
normal.
33
The
picture
doesn't
Connection is incorrect.
• Check and correct connections.
10-11
appear on the television.
The television's input mode is incorrect.
• Change
the
input
mode
to
suit
the
connections between this unit and the
television.
-
Sound suddenly stops or
none is heard when the
unit is switched on.
"OVERLOAD" appears on
the display.
The
protection
circuitry
has
functioned
because: the positive and negative speaker
wires have shorted; speakers with a lower
impedance than this unit's rated impedance
are being used; the speakers are under
strain through excessive volume, excessive
power,
or
by
being
used
in
a
high
temperature environment.
• Switch off the unit, determine and correct
the cause, then switch the unit on.
• Use speakers with the right impedance
rating.
14-16
"F70" appears on the
display.
• Turn off the power and then turn it on
again, or disconnect the AC power supply
cord and then connect it to your household
AC outlet again.
(If "F70" remains on the display, consult an
authorized service center or your dealer.)
j
The RESET function
POWER,6/1
DIGITAL INPUT
While the unit is on
While pressing and holding [DIGITAL
INPUT], press and hold [POWER, 6/1] until
"RESET" appears on the display.
The operation settings for the unit will be initialized to the settings
made at the time of shipment.
However, any preset radio stations will not be erased.
RQT
5512
Publicité
