Publicité
Specifications
(ihf78)
■ AMPLIFIER SECTION
Rated minimum sine wave RMS power output
20 Hz-20 kHz both channels driven
0.09 % total harmonic distortion
100 W per channel (6 Q.)
1 kHz continuous power output both channels driven
0.05 % total harmonic distortion
105 W per channel (6 ft)
Total harmonic distortion
rated power at 20 Hz-20 kHz
0.09 % (6 ft)
half power at 1 kHz
0.03 % (6 ft)
Power bandwidth
both channels driven,-3 dB
10
Hz-
Power output at the DVD 6CH operation
20 Hz-20 kHz (each channels driven)
0.09 % total harmonic distortion
-70 kHz (6 0,0.9 %)
Front
2 x 100 W (6 ft)
Center
100 W (6 ft)
Surround
2 x 100 W (6 ft)
Low frequency damping factor
Load impedance
Front
30 (6 a)
A or B
4-8
a
A and B
8ft
BI-WIRE
6-8 0
Center
6-8 0
Surround
Frequency response
6-8 ft
■ FM TUNER SECTION
Frequency range
87.9-107.9 MHz
Sensitivity
11.2 dBf (2 mV, IHF '58)
50 dB quieting sensitivity
MONO
18.3 dBf (4.5 mV, IHF'58)
STEREO
38.3 dBf (45 mV, IHF '58)
Total harmonic distortion
MONO
0.2 %
STEREO
0.3 %
S/N
MONO
73 dB
STEREO
67 dB
Frequency response
20 Hz-15 kHz, +1 dB, -2 dB
Alternate channel selectivity
65 dB
Capture ratio
1.5 dB
Image rejection at 98 MHz
40 dB
Spurious response rejection at 98 MHz
75
dB
AM suppression
50 dB
Stereo separation
1 kHz
40 dB
10 kHz
30 dB
Antenna terminal
75 ft (unbalanced)
■ AM TUNER SECTION
Frequency range
530-1710 kHz
Sensitivity
20 mV, 330 MV/m
Selectivity
55 dB
IF rejection at 1000 kHz
50 dB
PHONO
RIAA standard curve ±0.8 dB
CD, DVD, TV, VCR 1, VCR 2, VCR 3 (SA-DA10/DA8 only),
TAPE
10 Hz-100 kHz, ±3 dB
Input sensitivity
PHONO
0.4 mV (3 mV, IHF '66)
CD, DVD, TV, VCR 1, VCR 2, VCR 3 (SA-DA10/DA8 only),
TAPE
27 mV (200 mV, IHF '66)
S/N (IHF A)
(VGCA ON)
PHONO
80 dB (80 dB, IHF '66)
CD, DVD (L/R/C/LS/RS), TV, VCR 1, VCR 2,
VCR 3 (SA-DA10/DA8 only), TAPE
113 dB (IHF A, Rated Power, S=2 V)
90 dB (100 dB, IHF'66)
Input impedance
PHONO
47 kft
CD, DVD, TV, VCR 1, VCR 2, VCR 3 (SA-DA10/DA8 only),
TAPE
22 kO
Tone controls
BASS
50 Hz,+10 to-10 dB
TREBLE
20 kHz,+10 to-10 dB
Subwoofer frequency response
(-6 dB)
7-200 Hz
■ VIDEO SECTION
Output voltage at
1 V
input (unbalanced)
1±0.1 Vp-p
Maximum input voltage
1.5 Vp-p
Input/output impedance
75 ft
■ GENERAL
Power supply
AC 120 V, 60 Hz
Power consumption
310 W
Dimensions (W x H x D)
[SA-DA10] 430 x 180 x 370 mm
(16-15/16" x 7-3/32" x 14-9/16")
[SA-DA8/DX1040] 430 x 158 x 370 mm
(16-15/16" x 6-7/32" x 14-9/16")
Mass
[SA-DA10] 12.7 kg (28.0 lb.)
(SA-DA8/DX1040] 11.7 kg (25.8 lb.)
1 Power consumption in standby mode:
1 W )
■ DIN POWER (1 kHz T.H.D. 1 %)
2x 100 W(6 ft)
Notes:
Digital input (OPTICAL)
CD, DVD, TV
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer,
Maintenance
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a
soap-and-water solution or a weak detergent solution.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that
came with the cloth carefully.
---■
Product Service
Do not attempt to remove the cover(s) or repair the unit yourself.
Refer servicing to qualified personnel only.
Product information
For product service, product information or assistance with
product operation, refer to the servicenter directory.
45
RQT5512
Publicité
