Publicité
The radio
SA-DA10
| SA- DA8/DX1040
2
3
1
SA-DA10
| SA-DA8/DX1040 |
Selected band
Direct tuning
by remote control only I
Specify the frequency using the numbered buttons on the remote
control to directly tune to the station.
1
Press [TUNER/BAND].
This will set the remote control to operate the tuner.
The selector on the receiver will change to "TUNER".
Each time you press the button, the band will change as
follows,
FMzH AM.
2
Press [DIRECTTUNING/DISC ENTER].
3
While the cursor is flashing (approx. 10 seconds)
Press the numbered buttons to enter
the frequency.
Tuning interval
FM: 0.1 MHz
. AMMO kHz
if the desired FM frequency is 107.9 MHz, press
E]->GD-»lZMI].
If the frequency has been input correctly, the displayed
frequency will blink once.
Note
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received.
To re-specify the frequency, repeat the procedure from
step 2.
2. If the frequency has not been input correctly, "ERROR"
will be displayed.
In this case, re-enter the frequency.
i
SA-DA10
1 SA-DA8/DX1040
©
©
® ®
666
29
RQT5512
Publicité
