Publicité
o Connecting the mains cable
Earth must always be connected. Power cables must be approved and comply with the IEC Standard.
Maximum 3 units can be connected in series
Care and maintenance
The outside of the camera should be cleaned regularly. The lenses must be cleaned to ensure optimum
brightness. If the luminaire is installed in a dusty or smoky environment, regular cleaning is very important.
Unplug the device before carrying out any work!
Use a clean, dry cloth.
Risk of electric shock.
Always unplug the appliance before servicing or performing any maintenance.
Here are a few suggestions if you have any problems with your device.
The appliance does not work at all.
o Check the power cord and fuse.
o Make sure that your plug is correctly plugged in.
The fixture does not respond or does not respond correctly to DMX commands.
o Check your DMX cables
o Check your DMX addressing
o Try another DMX controller
o Check that your DMX cables do not run close to high-voltage cables, which could cause
interference.
Does not react to sound
o Check the selected operating mode
o Check that there is no DMX cable connected to DMX IN
o Tap directly on the microphone to test its responsiveness.
Technical specifications
Power supply
Power consumption
LED
DMX channels
Control
Device dimensions
Net Weight
THUNDER KOLOR User's Manual Ver. 1.00
DANGER!
100-240 V AC, 50/60 Hz ~
1040W
588 RGB + 144 CW
5/14/23/68 ch
DMX, RDM
520 x 326 x 137mm
11.2KG
17
Page
Publicité
