Preparing The Tool - DeWalt DCN45RN Guide D'utilisation

English
Fig. B
1
Proper Hand Position (Fig. C)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the handle
Fig. C
Bump Action
Bump action is intended for rapid nailing on flat, stationary
surfaces and typically most effective for applications that
require driving shorter nails.
To Operate the Tool Using the Bump Actuation Method
1. Depress the trigger.
2. Push the contact trip against the work surface. As long
as the trigger is depressed, the tool will fire a nail every
time the contact trip is depressed. This allows the user
to drive multiple nails in sequence.

WARNING: Do not keep trigger depressed when tool
is not in use. Keep the trigger lock-off in the locked
position when the tool is not in use.

WARNING: When the tool's motor is running, the
next actuation, pulling the trigger or depressing the
contact trip, will cause a nail to fire.
10

Preparing the Tool

NOTICE: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This
can seriously affect the life and performance of
the tool.
nOTE: The battery pack is not fully charged out of the
2
carton. Follow instructions outlined (refer to Charging
a Battery).
1. Read the Nailer Safety Warnings section of
this manual.
2. Wear eye and ear protection.
3. Remove battery from tool.
4. Ensure magazine is empty of all fastners.
5. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use
a tool that has the contact trip restrained in the
actuated position.
6. Keep tool pointed away from yourself and others.
7. Insert fully charged battery pack.
Using the Trigger Lock-Off (Fig. D)
10 .

WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. D)
when the tool is not in use.

WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack
from tool and remove nails from magazine before
making adjustments.
Each D WALT nailer is equipped with a trigger lock-off
e
which when pushed to the right as shown in Figure D,
10
prevents the tool from firing a nail by locking the trigger and
bypassing power to the motor.
Fig. D
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off (Fig. D) whenever any adjustments are made or
when tool is not in immediate use.
NOTICE: Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
battery life, store battery packs out of the tool or
charger in a cool, dry location.
4
4