Publicité
Removing Collected Water (cont.)
NOTES
•
When you remove the bucket, do not touch any parts inside
the unit. Doing so may damage the product.
•
Be sure to push the bucket gently all the way into the unit.
•
When the unit is on, if the bucket is removed, the compressor
and the fan turn off , then the unit will beep 8 times and the
digital display shows Eb.
•
When the unit is off, if the bucket is removed, the unit will
beep 8 times and the digital display shows Eb.
2. Continuous draining
•
Water can be automatically emptied into a fl oor drain by
attaching the unit with a water hose (Id Ø 5/16", not included)
with a female threaded end (ID: M = 1", not included).
•
Remove the plastic cover from the back drain outlet of the
unit and set aside, then insert the drain hose through the
drain outlet of the unit and lead the drain hose to the fl oor
drain or a suitable drainage facility. (See Fig. 7 and Fig. 8)
•
When you remove the plastic cover, if there is some water in
the back drain outlet of the unit you must dry it. Make sure
the hose is secure so there are no leaks and the end of the
hose is level or down to let the water fl ow.
•
Direct the hose toward the drain, making sure that there are
no kinks that will stop the warter fl owing.
•
Select the desired humidity setting and fan speed on the
unit for continuous draining to start.
NOTE
When the continuous draining feature is not being used,
remove the drain hose from the outlet, and dry the water in
the continuous drain hose outlet.
NOTE
Do not use this operation when the outdoor temperature is
equal to or less than 32°F (0°C), otherwise water may freeze
causing blockages and the unit may cease to function properly.
Make sure to empty the bucket at least once a week when
using the pump draining feature. When the pump draining
feature is not being used, remove the pump drain hose from
the outlet.
Page 10
3. Pour the water out.
Fig. 6
Remove the
plastic cover
rotating counter-clockwise
Fig. 7
Drain hose
Fig. 8
User Manual
Publicité
