Publicité
Setting the Timer ON and Timer OFF
•
When the unit is on, fi rst press the Timer
button, the Timer OFF indicator light
illuminates. It indicates the Timer OFF program
is initiated. Press it again the Timer ON
indicator light illuminates.It indicates the Timer
ON is initiated.
•
When the unit is off , fi rst press the Timer
button, the Timer ON indicator light
illuminates. It indicates the Timer ON program
is initiated. Press it again the Timer OFF
indicator light illuminates. It indicates the
Timer OFF is initiated.
•
Press or hold the
and
key buttons to
change the Timer by 0.5 hour increments, up
to 10 hours, then at 1 hour increments up to
24 hours. The control will count down the time
remaining until start.
•
The selected time will register in 5 seconds and
the system will automatically revert back to
display the previous humidity setting.
•
When the Timer ON and Timer OFF times
are set, within the same program sequence,
indicator lights illuminate identifying both ON
and OFF times are now programmed.
Removing Collected Water
There are two ways to remove collected water:
1. Use the bucket
•
When the unit is off , if the bucket is full, the Full indicator
light will light.
•
When the unit is on, if the bucket is full, the compressor and
the fan turn off , and the Full indicator light will light, the
digital display shows P2.
•
Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does not
spill. Do not put the bucket on the as because the bottom of
the bucket is uneven. Otherwise water may be spilled.
•
Throw away the water and reposition the bucket.
•
The unit will restart operation when the bucket back in place.
User Manual
•
Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Timer function.
•
When LED display window displays the code
of P2, the Auto Start/Stop function will also
be cancelled.
NOTES
•
When first using the dehumidifier, operate
the unit continuously 24 hours. Make sure
the plastic cover on the continuous drain
hose outlet install stightly properly so there
are no leaks.
•
This unit is designed to operate with a
working environment between 5°C/41°F
and 32°C/90°F.
•
Make sure the water bucket is positioned
correctly so that the unit can operate
properly. When the water in the bucket
reaches to a certain level, please be careful
to move the unit to avoid it spill.
1. Pull out the bucket.
2. Hold both sides of the
bucket evenly, and pull
it out from the unit.
Fig. 5
Page 9
Publicité
