Publicité
Step 13
1
D12
Groove
å
Insert the DRAWER SIDES (D12 and D13 ) at an angle
into the slot at each end of the DRAWER FRONT (K).
3
Minimum
190 degrees
M67
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M67) to the DRAWER
FRONT (K). Tighten one HIDDEN CAM.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D13
K
Maximum
Arrow
210 degrees
Hidden part using
recycled material.
Color may vary.
K
2
U n fi
n i s h
s u r
f a c
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D723) into the grooves in
the DRAWER SIDES (D12 and D13) and DRAWER FRONT (K).
4
D115
D12
M67
å
Fasten the DRAWER BACK (D115) to the DRAWER
SIDES (D12 and D13) and DRAWER BRACE (M67). Use five
BLACK 1-9/16" FLAT HEAD SCREWS (30S). Repeat this
step for the other DRAWERS (J and L).
420834
9
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
e
D723
D13
K
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(15 used in this step)
D13
Page 17
Publicité
