Publicité
English
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Four accessories are available for the DW735
Thickness Planer.
•
DW7350 Mobile Stand
•
DW7351 Folding Tables
•
DW7352 13" (325 mm) Knives
•
DW7353 Chip Ejection Accessory
nOTE: Helical cutterheads have not been tested with this
product and are not recommended for use.
DW7351 Accessory Folding Tables (Fig. AA)
WARNING: For your own safety, read the tool
instruction manual before attaching the tables.
Failure to heed these warnings may result in personal
injury and serious damage to the planer and the
accessory. When servicing this tool, use only identical
replace ment parts. Have damaged cords replaced by
an authorized service center.
Your DW7351 folding table box should include:
2 folding tables
4 cap screws
4 springs
Fig. AA
Set-up and Installation of Base
Hardware (Fig. BB–DD)
1. Place planer on a secure table or workbench. Position
planer so the front 3–4" (75–100 mm) of the base can
be accessed from the underside.
2. Secure the rear of the planer to the table/bench with
nails or screws to prevent it from tilting or falling from
the table.
WARNING: The planer could tilt or fall from the table
if it is not properly secured opposite the end where
the folding table is being installed. Serious injury
may result.
3. Place the spring onto the small end of the stepped bolt.
4. Insert the end of the bolt with the spring around it into
the larger hole on the side of the base.
5. Push the stepped bolt all the way through the hole in
the first rib on the underside of the planer. The spring
should engage the rib slightly and the threads should
show on the right side of the rib.
6. On the underside of the planer, use a wrench to hold
the nut in place while turning the stepped bolt into it.
The 5/32" (4 mm) hex wrench can be used to turn the
stepped bolt until it is fully secured (Fig. BB).
12
WALT Industrial
e
4 nuts
4 stepped bolts
Fig. BB
7. Install the smaller screw into the lower threaded hole on
the side of the base. Use the 5/32" (4mm) hex wrench to
tighten that fastener securely (Fig. CC).
8. Depress the top pin until it is flush with the base and
slide the top hole of the table over the pin and release
the pin so they lock together (Fig. CC, DD).
Fig. CC
Fig. DD
9. To attach the table to the rear of the planer, install the
bolts and spring following the above procedure.
Your tables should now fold up and down on the top screw
and rest on the bottom screw while in position for planing.
nOTE: To transport the planer with the tables, fold them up
and carry the unit as recommended by the planer manual.
WARNING: For your own safety, it is recommended
that two people carry this machine or serious injury
could result.
To Remove the Tables
1. Depress the spring-loaded bolts on the base and slide
each end of the table toward you so they disengage the
holes in the tables. You may want to use the T-wrench
from your planer to push the bolts flush with the base to
easily remove the tables.
2. Leave the hardware (stepped bolts and small cap screw)
in the base until you need to re-attach the tables.
Publicité
