Publicité
5. After installing the brushes, replace the top cover and
brush cover screen.
6. Before using the planer, run the unit for 10 minutes to
seat new brushes.
nOTE: If existing brushes do not need replacing, be sure to
maintain the same orientation when you reinstall them.
Calibrating the Depth Adjustment Scale
(Fig. X)
The depth adjustment scale
14
factory. However, with extended use, the depth adjustment
scale could show an incorrect measurement.
To check the depth adjustment scale, plane a piece of
scrap wood, noting the measurement on the depth
adjustment scale.
Measure the finished thickness of the workpiece. If the
thickness of the workpiece does not match the reading on
the depth adjustment scale, loosen the two screws
the red indicator. Adjust the pointer up or down until its
reading matches the finished thickness of the workpiece.
Securely re-tighten the screws.
Fig. X
23
14
Base Maintenance
Keep the table clean and free from oil, grease, and pitch.
Treat the table with paste wax to help maintain its
smooth finish.
Circuit Breaker Reset Button (Fig. Y)
Your planer is equipped with an 18 amp circuit breaker. If
your planer becomes overloaded and stops operating, turn
off the planer, let the unit sit for 2 minutes and press the
reset button
24
before you resume working.
Fig. Y
WARNING: To prevent the planer from starting
unexpectedly if power is interrupted by a circuit
breaker trip, make sure the switch is in the OFF
position before restoring power.
nOTE: Circuit breaker overload is often the result of dull
knives. Change your knives on a regular basis to avoid
on your planer is set at the
23
on
24
tripping your breaker. Check your knives before re-setting
the circuit breaker and continuing to plane.
See the Troubleshooting Guide for additional information
on circuit breaker trips.
Replacing the Drive Belt
Drive belts are available at extra cost at D
service centers. Replacement of the drive belt should be
performed by qualified service personnel.
Chip Ejection Fan (Fig. P–R, Z)
The chip ejection fan on your planer should
be cleaned or cleared of debris periodically.
Fig. Z
WARNING: Turn off and unplug the planer prior to
accessing the chip ejection fan.
To Access the Fan
1. Remove the top cover of the planer with the T-wrench.
2. Remove the dust shroud (Fig. P–R) and place it aside.
3. Remove the screws and clips around the fan housing.
4. Remove the fan housing and place it aside as shown.
The fan will now be exposed for cleaning.
See the Troubleshooting Guide for additional information.
WARNING: Be sure to properly attach the fan housing
and assemble the shroud and top cover correctly
before using your planer again.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
It is recommended that, once a year, you take or send the
tool to a D
WALT certified service center for a thorough
e
cleaning, inspection and lubrication of the gear case.
Accessories
WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
English
WALT authorized
e
WALT
e
11
Publicité
