встановлення. Невикористання correc т конфігурації апаратного забезпечення і чи слідувати
за правильні процедури можуть призвести до небезпечної ситуації, до людей і до пошкодження
систем м.
Ми не можемо гарантувати, що через неправильне використання пристрою не трапляються
аварії та пошкодження. Будь ласка, використовуйте цей продукт обережно та працюйте на свій
страх і ризик!
У разі відмови пристрою, відключіть його від живлення. Найшвидший спосіб зробити це -
від'єднавши адаптер живлення від розетки.
Це продукт класу А. У побутових умовах цей виріб може викликати радіоперешкоди, і в цьому
випадку від користувача може знадобитися вжити відповідних заходів!
Вплив радіочастотного випромінювання: Це обладнання MikroTik відповідає нормам
радіаційного опромінення Європейського Союзу, встановленим для неконтрольованого
середовища. Цей пристрій MikroTik слід встановлювати та експлуатувати не ближче 95
сантиметрів від вашого тіла, професіонала чи широкого загалу.
Виробник: Mikrotikls SIA, Unijas 2, Рига, Латвія, LV1039.
Federal Communication Commission Interference Statement
FCC ID: TV7LHGG60AD
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to ensure compliance.