Publicité
Troubleshooting
7
Troubleshooting
As with all technical devices, the flat clamp may develop failures. Please consult the following checklist in the first
instance in order to find out whether the failure can be easily solved. If not, please contact the manufacturer.
Problem
Clamp does not engage.
Clamp does not fit.
8
Repairs
• Reparaturen dürfen nur von einem Sachkundigen bzw. vom Hersteller durchgeführt werden.
• Es dürfen nur Original-Ersatzteile verwendet werden; ansonsten erlischt die Gewährleistung.
• Es dürfen keine Änderungen oder Umbauten vorgenommen werden.
• Vor Wiederinbetriebnahme muss eine Prüfung durch einen Sachkundigen erfolgen.
9
Warranty and liability
The warranty and the liability are no longer valid, if the equipment has not been assembled, installed, operated,
checked and maintained according to these instructions.
Any doubts about instructions should be raised with the manufacturer prior to use.
Prior to every operation the user must ensure that
•
the equipment is suited to the intended operation,
•
the functioning and the working condition of the equipment is examined,
•
the loads are suitable to be handled.
Failures are to be reported in writing to the supplier immediately, at the latest two weeks following delivery.
It is unacceptable for the client to repair failures or have them repaired by a third party, and then request to be
reimbursed for the costs.
According to the manufacturer's general contract conditions the equipment is under warranty for a period of
six months from the invoice date. Wearing parts are not covered by the warranty.
The manufacturer is not responsible for any damage occurring in the event of an installation error or insufficient
training by a third party, negligence, misuse or excessive stress of the equipment.
It is within the responsibility of the client to check prior to operation the functional condition of the equipment,
the suitability of the load to be handled as well as any damage to the load before and after transport/installation.
The manufacturer does not take responsibility for any additional claims, for instance, the right to compensation
for damage not caused to the equipment itself.
53100278
1. Is the sling twisted?
2. Is the angle lever tension correct?
3. Is the plate oily, icy or dirty?
4. Is the plate thickness within the clamping range of the clamp?
Does the plate have a conical shape?
5. Is the rubber coating worn out?
6. Does the weight of the plate exceed the safe working load?
7. Is the clamp damaged or deformed?
1. Is the plate thickness within the clamping range of the clamp?
11 / 13
Solution
GB
Publicité
