Télécharger Imprimer la page

probst FZ Instructions D'emploi page 29

Masquer les pouces Voir aussi pour FZ:

Publicité

Initial operation and control
The Flat Grab FZ is designed for the safe transport of individual plates with
parallel surfaces. Care must be taken to ensure that the safe working load is
not exceeded and the clamping range respected. Always lift load vertically. It
is unsafe to lift at an angle. (Fig. 2).
5
Initial operation and control
5.1
Initial operation
• Die The fully assembled flat clamp is delivered in a cardboard box.
• Remove package material and check quantity, and damage, if any.
• Prior to initial operation it must be ensured that the flat clamp is suited for
the transport of the plate:
The material to be transported must be of sufficient construction to
-
withstand the forces during transport, especially when putting down the
plate.
-
The weight of the plate may not exceed the safe working load of the clamp.
-
The thickness of the plate must correspond to the clamping range of the clamp.
• The client must ensure that prior to operation the functioning and working
condition of the flat clamp is examined by an expert and that any defects
found are repaired.
• Fit loop of the sling in the load hook of the material handling lifting
equipment. It must be ensured that the sling is not twisted and that it can
be easily pulled through the jaw.
• Operate flat clamp using the handles only: risk of injury!
53100278
9 / 13
Fig. 2
Fig. 3
Fig. 4
GB

Publicité

loading